Neuton Garden Cart Safety & Operating Instructions Manual page 20

7. Plug in the Wire Harness
•
Connect the wire harness to the underside of the
controls caddy.
•
If you haven't already, tilt the Cart forward onto its
nose.
•
Take the wire harness cable and run it up along the
right side of the handle's tubing.
•
Plug the connector end of the wire harness into the
switch connector underneath the controls caddy
(Figure 7). It will only install one way. The wire colors
will be aligned such as red to red on one end.
•
Press securely and the locking tab on the connector
snaps into position. This prevents the wire harness
from accidentally pulling away from the switch
connector.
8. Secure the Wire Harness
Tie the wire harness to the handle's tubing; this helps
keep the wire harness safely out of the way when using
the Cart.
•
Put the Cart back onto its wheels.
•
Take the tie wraps from the red hardware bag. One by
one, place the tie wraps around the wire harness and
handle's tubing (in the locations shown in Figure 8),
slip the end into the tab, and pull tightly.
®
16 NEUTON GARDEN CART
Safety & Operating Instructions
Figure 7. Connect the wire Harness to the switch
connector underneath the controls caddy.
Figure 8. Securing the wire harness to the handle.