Accessory Kit Contents; Hdd Installation; Rack Installation - GENIV G4-RTAHD Series User Manual

Accessory Kit Contents

One (1) power cable
One (1) Ethernet cable
Four (4) SATA II data cables
One (1) external audio extension cable
One (1) remote control
One (1) USB mouse
One (1) CD containing the DVR manual, client software and software tools
One (1) package of HDD installation screws, rack mounting brackets, etc
Note: The contents of the accessory kit are subject to change without notice

HDD Installation

If your DVR was ordered with a hard disk drive (HDD) preinstalled, you may skip this step. This
procedure may also be used at a future date to add additional storage capacity to your DVR. Please
refer to the User's Manual for recommended HDD brands and models.
Please follow the instructions below to install/add a HDD.
Remove the top cover from the
DVR.
Unfasten the HDD power cable.

Rack Installation

The DVR will occupy two units of vertical rack space (2U).
Attach the rack mount brackets to the DVR using 3 screws each provided in the accessory
•
kit.
Mount the DVR within the rack using 4 screws (not provided).
•
Always mount equipment within a rack from the bottom up.
•
If possible, it is advised to leave one rack unit of space between devices for ventilation.
•
Ensure that the temperature is below 95° Fahrenheit (35° Celsius).
•
Always ensure that sufficient power is provided for electronic components and that the power
•
is conditioned using a surge protector or uninterruptable power supply (UPS).
Align the HDD with the holes
provided on the HDD bracket.
Attach the SATA cable to the
HDD and to the system board.
Using four screws, attach the
HDD to the bracket.
Attach the power cable to the
HDD.