Advertisement
Install
Check the measurements on fig 3 to confirm the requirements
for your installation. Please note, the oven dimensions show a
standard CDA oven and will vary depending on the appliance
being installed above the warming drawer.
1. Connect the mains lead to the product before installation. Run
the lead to the socket outlet to be used and connect to the
mains electrical supply. Do not switch on until installation is
complete.
2. Locate the product centrally on the supporting shelf and fix
into position using the fixing screws and plastic supports (fig
2).
3. Carefully fit the appliance on top of the warming drawer,
taking care not to scratch the top stainless edge of the drawer
unit. Ensure that the mains connection lead is located near to
the socket outlet to avoid having to remove the product again
to connect the mains electrical supply.
4. Secure the oven into the housing using appropriate fixing
screws.
5. The warming drawer is supplied with three metal filler
strips with a self-adhesive backing. These strips should be
attached to the warming drawer to seal any gaps between the
appliance and the housing. Remove the protective foil from
the trim and position the trim as shown in fig 1 so they are
flush with the rear and side walls of the housing, then attach
to the warming drawer. If there is no rear wall to the housing,
the rear trim is not required.
The casing of this appliance will get hot.
Ensure that any cables that may come
into contact with the appliance once
installed are suitable for use at 85°C.
6
Fig. 1
Fig. 2
573
545
548
6
Fig. 3
20-24
594
598
128
289
595
23
6
20-24
594
573
598
545
276
595
548
23
Advertisement
