Table of Contents
Advertisement
05
Listening to your system
Playing other sources
1
Turn on the power of the playback
component.
2
Turn on the power of the receiver.
3
Select the source you want to playback.
Use the MULTI CONTROL buttons (INPUT
SELECTOR).
4
Start playback of the component you
selected in step 1.
Choosing the input signal
On this receiver, it is possible to switch the
input signals for the different inputs as
described below.
1
Press SIGNAL SEL to select the input signal
corresponding to the source component.
When DIGITAL (C1/O1/O2) or HDMI (H) is
selected and the selected audio input is not
provided, A (analog) is automatically selected.
Each press cycles through the following:
• A – Selects the analog inputs.
• DIGITAL – Selects the digital input. The
coaxial 1 input is selected for C1, and the
optical 1 or 2 audio input is selected for
O1 or O2.
• HDMI – Selects an HDMI signal. H can be
selected for BD/DVD or TV/SAT input. For
other inputs, HDMI cannot be selected.
Note
1 • This receiver can only play back Dolby Digital, PCM (32 kHz to 96 kHz) and DTS (including DTS 96 kHz / 24 bit) digital signal
formats. The compatible signals via the HDMI terminals are: Dolby Digital, DTS, SACD (DSD 2 ch), DVD Audio (including 192
kHz), PCM (32 kHz to 192 kHz sampling frequencies). With other digital signal formats, set to A (analog) (the MULTI IN or
TUNER).
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 9) and set the signal input to C1/O1/O2 (DIGITAL).
• Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
2 • When the HDMI option in Setting the Audio options on page 30 is set to THRU, the sound will be heard through your TV, not
from this receiver.
3 • During playback from the multichannel inputs, you can't use any of the sound features/modes and only the volume and
channel levels can be set.
• Change the output settings of the systems with multichannel analog outputs according to the number of the speakers
connected to the receiver.
32
En
1
When set to DIGITAL or HDMI, 2 D lights
when a Dolby Digital signal is input, and DTS
lights when a DTS signal is input.
When the HDMI is selected, the A and
DIGITAL indicators are off (see page 21).
Selecting the multichannel
analog inputs
If you have connected a decoder or a BD/DVD
player with multichannel analog outputs to this
receiver (page 10), you must select the analog
multichannel inputs for surround sound.
•
Press MULTI IN on the remote control.
To cancel playback from the multichannel
inputs, switches to the other input signal.
Using the headphone
1
Insert the headphone into the PHONE
jack.
2
Press RECEIVER then press the SPEAKERS
button to select SP OFF.
The sound is heard from the headphone and no
sound is heard from the speakers connected to
this receiver.
The listening mode when the sound is heard
from the headphone can be selected only from
STEREO or A.L.C..
2
3
Advertisement
Table of Contents
