Panasonic Viera TC-L42ET60H Owner's Manual page 3

■
About built-in wireless LAN
●
To use the built-in wireless LAN, using an access point is recommended.
●
To use the built-in wireless LAN in the access point mode, up to 7 devices are connectable. But the
transfer rate will vary according to communication environment or connected equipments.
●
Do not use the built-in wireless LAN to connect to any wireless network (SSID*
not have usage rights. Such networks may be listed as a result of searches. However, using them
may be regarded as illegal access.
●
Check that the Access point supports WPS*
(If it does not support WPS, the encryption key of the Access point is required when configuring
settings.)
●
Follow the instructions on the Access point setup screen and configure the appropriate security
settings.
For more details on setting of Access point, please refer to operating manual for the Access point.
●
We recommend using 11n (5 GHz) for the wireless system between the built-in wireless LAN and
Access point.
Communication is also possible with 11a, 11b, and 11g, but the communication speed may be slower.
●
If the wireless system of the Access point is changed, devices that could connect by wireless LAN
may no longer be able to connect.
●
Data transmitted and received over radio waves may be intercepted and monitored.
●
Keep the TV away from the following devices as much as possible:
Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the
TV failures such as malfunction may occur due to the radio wave interference.
●
When noises occur due to the static electricity, etc., the TV might stop operating for the protection
of the devices. In this case, turn the TV Off with power On / Off switch, then turn it On again.
* SSID is a name for identifying a particular wireless network for transmission.
1
* WPS: Wi-Fi Protected Setup
2
2
.
2
) for which you do
1