WiFi Phone(U-Phone) User’s Manual Table of Contents Chapter 1 Overview of the WIFI PHONE....5 1.1 Front Panel and Keypad ........... 5 1.2 Removing and Installing the Battery......7 1.3 Charging the WIFI PHONE ........8 1.3.1 Charging the WIFI PHONE by using the Travel Charger ...................
Page 3
WiFi Phone(U-Phone) User’s Manual Chapter 6 SIP Settings..........20 6.1 Display Name ............21 6.2 SIP User Name............21 6.3 Realm name ............21 6.4 Authentication Name..........21 6.5 Password..............21 6.6 Registrar ..............21 6.7 Registrar Status ............21 6.8 Registration Time (sec) ...........
Page 4
WiFi Phone(U-Phone) User’s Manual Chapter 9 System Time ........... 28 9.1 Time Setting............28 9.2 SNTP Setting ............29 9.2.1 Time Zone Setting............ 29 9.2.2 SNTP Status ............29 9.2.3 Polling Time ............. 29 9.2.4 SNTP Server 1 to 4 ..........29 Chapter 10 Information..........
User’s Manual Chapter 1 Overview of the WiFi phone WiFi phones (U-Phone) are compliant to IEEE 802.11b standard and IETF Session Initiation Protocol (SIP). As long as users are in the coverage of APs (Access Point), they can use WIFI PHONE to make VoIP phone calls over WLAN.
WiFi Phone(U-Phone) User’s Manual LED Indicator: ON – When the WIFI PHONE is in wake up mode, WLAN packets can be transmitted or received by the WIFI PHONE. OFF – When the WIFI PHONE is in sleep mode, no WLAN packets can be transmitted or received by the WIFI PHONE.
WiFi Phone(U-Phone) User’s Manual 1.2 Removing and Installing the Battery To remove the battery: Turn the handset face down and locate the battery release button at the middle of the handset. Push the release button and lift the battery up to remove it.
WiFi Phone(U-Phone) User’s Manual 1.3 Charging the WIFI PHONE Before the first time use of the WIFI PHONE, please charge it for at least six hours. The battery icon on the LCD display will show the charging status. Please refer to figure 1.3.1.
WiFi Phone(U-Phone) User’s Manual Figure 1.3.2.1 WIFI PHONE on the desktop charger 1.4 Powering the WIFI PHONE On and Off Press and hold the Power On/Off key for approximately 2.5 seconds to turn the WIFI PHONE on or off. 1.5 Main Screen After powering on, the phone enters standby mode, with the main screen displayed, as shown in Figure 1.4.1...
WiFi Phone(U-Phone) User’s Manual 8 Time 1.6 Entering and Editing text In many situations you need to enter numbers and characters in an entering field. Please refer to the following guidelines: • Press to switch between upper case character, lower case character and numeric mode, with the icon shown at the middle of the bottom of LCD screen respectively.
WiFi Phone(U-Phone) User’s Manual directly by pressing the left soft key. 1.8 Answering a Call When talking you can use ▲ and ▼ to To answer a call, press adjust the volume. To reject a call, press Please refer to Figure 1.8.1...
WiFi Phone(U-Phone) User’s Manual Chapter 2 Menu Architecture In the standby mode, you can press the right soft key to select the Phonebook menu or press the left soft key to select the main Menu. 08:55 user WLAN Ready Main Menu...
Page 13
WiFi Phone(U-Phone) User’s Manual 1. Call History 2. Phone Settings 3. SIP Settings Select Back Figure 2.0.3 Main Menu...
WiFi Phone(U-Phone) User’s Manual Chapter 3 Phonebook This chapter provides information about accessing the Phonebook menu and using its features. Figure 3.0.1 shows the architecture of the Phonebook menu. Phonebook Browse View Edit Delete User Name Create SIP URL Apply Review Figure 3.0.1 Phonebook menu architecture...
WiFi Phone(U-Phone) User’s Manual to select it. 2. Press ▲ or ▼ to scroll to the name you want to browse. Then press to select it. 3. Now you can view, edit or delete this record. 4. When viewing one record, you can recall the phone number/SIP URL of that record by pressing the left soft key and then make a call.
WiFi Phone(U-Phone) User’s Manual Chapter 4 Call History This chapter provides information about accessing the Call History menu and using its features. Figure 4.0.1 shows the architecture of the Call History menu. Call History Outgoing Calls Incoming Calls Missed Calls Erase Record Figure 4.0.1 Call History menu architecture...
WiFi Phone(U-Phone) User’s Manual You can press ▲ or ▼ to scroll through the last 10 phone numbers dialed, and press to make a call of that number. 4.2 Incoming Calls In the Call History menu, select Incoming Calls. The Incoming Calls menu is displayed, as shown in Figure 4.2.1.
WiFi Phone(U-Phone) User’s Manual Chapter 5 Phone Settings This chapter provides information about accessing the Phone Settings menu and using its features. Figure 5.0.1 shows the architecture of the Phone Settings menu. Phone Settings Ringer Melody Off/on Melody Select Melody 1 to 11...
WiFi Phone(U-Phone) User’s Manual 5.2 Melody Select You can select ringer melody from Melody 1 to Melody 11. Then you can play the melody and set it active. 5.3 Key Tone This feature allows users to decide if there is key tone when keypad is pressed.
WiFi Phone(U-Phone) User’s Manual Chapter 6 SIP Settings This chapter provides information about accessing the SIP Settings menu and using its features. Figure 6.0.1 shows the architecture of the SIP Settings menu. SIP Settings Display Name SIP User Name Realmname Auth.
WiFi Phone(U-Phone) User’s Manual In the main Menu, press ▲ or ▼ to scroll to SIP Settings. Then press to select it. The SIP Settings menu is displayed, as shown in Figure 6.0.2 1. Display Name 2. SIP User Name 3.
WiFi Phone(U-Phone) User’s Manual 6.10 Proxy Status You can enable or disable the WIFI PHONE to use the SIP proxy server. 6.11 Outbound Proxy The outbound proxy is used to do NAT/Firewall traversal for users sitting behind NAT/Firewall equipments. Enter the outbound proxy server’s IP address and port number here.
WiFi Phone(U-Phone) User’s Manual Chapter 7 IP Settings This chapter provides information about accessing the IP Settings menu and using its features. Figure 7.0.1 shows the architecture of the IP Settings menu. DHCP Disable/Enable IP Settings System Name Static IP Address...
WiFi Phone(U-Phone) User’s Manual Note 1: After any modification of settings in this IP settings menu, you need to reboot the WiFi Phone to make the new settings effective. Note 2: Please don’t use the following subnets on the WIFI PHONE- 192.168.1.x and 192.168.99.x.
WiFi Phone(U-Phone) User’s Manual Chapter 8 WLAN Settings This chapter provides information about accessing the WLAN Settings menu and using its features. Figure 8.0.1 shows the architecture of the WLAN Settings menu. WLAN Settings SSID Channel 1/2/5.5/11Mbps/Auto Tx Rate Mode...
WiFi Phone(U-Phone) User’s Manual In the main Menu, press ▲ or ▼ to scroll to WLAN Settings. Then press to select it. The WLAN Settings menu is displayed, as shown in Figure 8.0.2 1. SSID 2. Channel 3. Tx Rate...
WiFi Phone(U-Phone) User’s Manual 8.7.1 Authentication Type You can choose open system or shared key as the authentication type. 8.7.2 Encryption You can disable it or you can enable it with 64 or 128 bit key. 8.7.3 Used Key You can choose any key from key 1 to key 4 for WEP encryption.
WiFi Phone(U-Phone) User’s Manual Chapter 9 System Time This chapter provides information about accessing the System Time menu and using its features. Figure 9.0.1 shows the architecture of the System Time menu. System Time Time Setting Clock Settings Date Settings...
WiFi Phone(U-Phone) User’s Manual 9.2 SNTP Setting 9.2.1 Time Zone Setting This submenu includes Time Zone and Daylight Saving configuration. You can select the time zone in which you are located from the time zone list. You can disable or enable the daylight saving function. If you want...
WiFi Phone(U-Phone) User’s Manual Chapter 10 Information This chapter provides information about accessing the Information menu and using its features. Figure 10.0.1 shows the architecture of the Information menu. Information Registrar Status Proxy Status Current IP Addr WLAN Status Current SSID...
WiFi Phone(U-Phone) User’s Manual 10.2 Network Information Network and WLAN status can be shown here. 10.3 System Information You can get information about the Firmware Version, Serial Number and Hardware Version here.
WiFi Phone(U-Phone) User’s Manual Chapter 11 Profile This chapter provides information about accessing the Profile menu and using its features. In standby mode, you can press the hot key ‘ ’ to access the Profile menu. Figure 11.0.1 shows the architecture of the Profile menu.
WiFi Phone(U-Phone) User’s Manual WiFi Phone Unlock Figure 11.1.1 Key-locked screen You can unlock it by pressing twice. The phone will go to standby mode. 11.2 Speed Dial The Speed Dial menu allows users to dial a number from the list of placed calls.
WiFi Phone(U-Phone) User’s Manual Chapter 12 Web-based Management Interface WIFI PHONE has a Web-based management interface to provide users an easier way to configure WIFI PHONE. Some advanced configurations, like firmware upgrade, are only available by using this interface. 12.1 Login the Management Interface Start the IE (or other browsers) to navigate WIFI PHONE web management interface by entering the IP address (192.168.3.20 in the...
WiFi Phone(U-Phone) User’s Manual status and system information. On the left side of the main page, there are six configuration items: System, LAN, Wireless, SIP, Phone Settings and Phonebook. All of these configuration items will be described in the following sections.
WiFi Phone(U-Phone) User’s Manual Figure 12.3.0.1 System Setting Page 12.3.1 System Date & Time Clicking the System Date & Time option will bring you to the System Date & Time page. You can set date, time, time zone, enable or disable daylight saving function and using SNTP servers to get time information.
WiFi Phone(U-Phone) User’s Manual 12.3.3 Firmware Upgrade Clicking the Firmware Upgrade option will bring you to the Firmware Upgrade page as shown in Figure 12.3.3.1. You can upgrade the firmware of WIFI PHONE by using a FTP server. Please enter FTP server’s IP address, user name, password and the file name of the new firmware.
WiFi Phone(U-Phone) User’s Manual Figure 12.3.3.2 Confirmation Window Figure 12.3.3.3 Warning Window 12.3.4 Configuration Tools Clicking the Configuration Tools option will bring you to the Configuration Tools page. You can set WIFI PHONE back to its factory default settings in this option.
WiFi Phone(U-Phone) User’s Manual Figure 12.4.0.1 LAN Setting page 12.4.1 Dynamic IP Clicking the Dynamic IP option will bring you to the Dynamic IP page. This option allows you to enable the DHCP client function of the WIFI PHONE. 12.4.2 Static IP Clicking the Static IP option will bring you to the Static IP page.
WiFi Phone(U-Phone) User’s Manual Figure 12.5.0.1 Wireless Setting page 12.5.1 Setting Clicking the Setting option will bring you to the Wireless Settings page. This option allows you to set all the WLAN related settings, including General, Advanced Settings, Authentication and 802.1x, of the WIFI PHONE.
WiFi Phone(U-Phone) User’s Manual Figure 12.6.0.1 SIP Setting page 12.6.1 Setting Clicking the Setting option will bring you to the SIP Settings page. This option allows you to set all the SIP related settings, including User Information, Proxy Server, Outbound Proxy, Registrar and codec used by the WIFI PHONE.
WiFi Phone(U-Phone) User’s Manual Figure 12.7.0.1 Phone Settings page 12.7.1 Phone Settings Clicking the Phone Setting option will bring you to the Phone Settings page. This option allows you to set all the phone related settings, including Ringer Melody, Melody Select, Key Tone, Vibrator and Speaker Volume.
WiFi Phone(U-Phone) User’s Manual Figure 12.8.0.1 Phone Book page 12.8.1 Phone Book Edit Clicking the Phbook Edit option will bring you to the Phone Book Edit page. This option allows you to create, delete and browse items in the phone book.