Transmitter Controls - Innovator TS6 Instruction Manual

Transmitter Controls

14
9
13
3
2
4
15
16
8
10
12
5
1
6
7
11
17
1. Right Stick:Throttle/Aileron control for Mode1 type. Elevator/Aileron
control for Mode 2 type.
2. Left Stick: Elevator/Rudder control for Mode1 type. Throttle/Rudder
control for Mode 2 type.
3~6. Channel Trim TAB: Trim tabs to trim controls to neutral position on
each channel servo.
7. Power Switch Button: Turn the transmitter on or off.
8. Antenna: Bend the antenna up during flight.
9. Voltage Indicator: LED indicates the condition of the transmitter
battery. When blinking, it indicates the batteries are getting weak.
Change to new battery.
10. Handle: For carrying the transmitter..
11. Binding Switch: For performing binding process. Another function
of this switch is for range checking function.
12. Fly Mode Control Switch: To switch Mode settings during flight.
13. Auto Rotation/CH6 Control Switch: To drive auxiliary 6th channel
control such as auto rotation or others.
14. Trainer Switch: To switch primary control between student's and
instructor's transmitter.
15.
Fly Mode POS Switch: To match pilot's preferences, switch Fly
Mode by toggling Left or Light settings.
16. Simulator/Trainer mini USB Connector Port: To connect
transmitter to other by-wire devices.
17. Charging Jack: To recharge the transmitter battery pack (only use
rechargeable Nicd or NiHM battery pack).
NOTE:
Set the ON/OFF switch on "OFF" position before charging. Charger must be
plugged-in properly ("+" inside and "-"outside, type TAMIYA N-3U or
equivalent). The wrong type of batteries may provoke explosion causing
personal injuries and damages.
2