Panasonic Viera TC-P50VT25X Operating Instructions Manual page 23

Remove the insulating sheet
insulating sheet
Attach the specialized band
If the 3D Eyewear slips out of place, use the specialized band included to hold it in place.
Specialized band
Attach the nose pad
Nose pad A
When the remaining battery level is low, the Indicator lamp flashes 5 times upon turning the 3D Eyewear power ON.
(Early battery replacement is recommended.)
Loosen the screw from the cover using the
screwdriver (included).
Replace the battery, and then replace the
cover.
Using for the first time
Attach the band to the left and right tips of the frame, and adjust the
length.
If required, use the included nose pad.
Nose pad A adjusts the attachment position of the 3D Eyewear between 2
vertical levels.
(Slot 2 of the 3 protrusions on the 3D Eyewear deeply into the holes on nose
pad A.)
When using nose pad B, ensure that all 3 protrusions on the 3D Eyewear are
inserted deeply into the 3 holes on nose pad B.
Replacing the batteries
screwdriver
Note
Use the specified type of battery (coin-shaped lithium
battery CR2032).
Do not insert the battery with the polarity (plus
minus ) backwards.
Dispose of the old batteries as non-burnable garbage, or
in line with the garbage regulations in your local area.
Always tighten the screw to hold the battery case cover
in place.
and
23