You have purchased one of the finest wood burning heating systems in North America. You will find that your Ardent Energy furnace will operate much differently than the old fashioned fireboxes of the past. You will experience a new level of heating comfort and convenience, with greater control, longer burn times and reduced creosote deposits.
Furnace Operation 3. DO NOT use gasoline type lantern fuel, kerosene, charcoal SAFETY lighter fluid or similar liquids to start or freshen up the fire in this furnace. Keep all such liquids well away from the furnace WARNING: If this furnace is not properly installed, a house while it is in use.
• When you are starting a fire, the bypass damper should be open to vent away smoke. • The furnace door must be closed at all times, except Wood when you are loading fuel or checking the fire. Burning F75R F101 Module No. Rating..(KW).. `1400 - 20000 `1400 - 27000...
• To tighten the door, loosen the bottom nut and tighten the top nut Figure 3: F75R door adjustment • To adjust the door in and out, Figure 2: Operation during a power failure loosen the top two nuts, adjust the door.
If you are using an existing chimney, it must be inspected The F75R and F101 furnaces may be installed as follows: carefully for soundness and to be sure that the preceding 1.
(9/32") or thicker of noncombustible material extending 150 mm Be sure that you have the following: (6") from the sides and rear, and 460 mm (18") from the front. • Wood furnace module # F75R or F101 • Blower - Delhi model 210 or Lau DUA10 DUCT WORK •...
Be sure that you have the following: The temperature rise (outlet temperature minus the • Wood furnace module # F75R or F101 inlet temperature) should not exceed 30° C (85° F). If so, • Control kit model FCFC2 or FCFC3, which includes: increase the blower speed so that the temperature rise is •...
Be sure that you have the following: If any changes are required on the oil furnace, these must • Wood furnace module # F75R or F101 comply with CSA Standard B139 "Installation Code for Oil • Control kit model FEFC3, which includes: Burning Equipment."...
6. Connect the piping, close the drain and open the valves to the boiler. ARDENT Energy furnaces are designed to heat your domestic hot water during the heating season. The F75R and WHEN YOU HAVE NO WATER F101 can accept 1 or two coils (1 per side). When you install the water coil (part FCSHW4) it replaces all but one of the Do not operate your furnace with a dry water coil.
Furnace Options for circulation, disconnect and remove the coil. To seal the holes, use two 25 mm (1") diameter standard washers per hole, and use a 19 mm x 25 mm (3/4" x 1") bolt to hold the washers together. PAINT You may touch up the face of the furnace with STOVE BRIGHT Satin Black 1990 high temperature paint.
Page 12
Replacement Parts F75R Replacement Parts ITEM QTY/UNIT DESCRIPTION PART# rear top shroud A399P back shroud liner assy A414W bypass damper assy A237W bypass lever A239W flame deflector A533 outside fin A407 water coil (optional) FCSHW4 side shroud door A398 bypass assembly...
Page 14
6. Any shipping charges incurred during a warranty claim will be borne by the furnace owner. 7. The remedies set forth herein are exclusive, and the liability of Ardent Energy Inc with respect to any contract, tort, under any warranty or otherwise shall not exceed the price of the equipment or...