Exadigm GT Quick Start Manual

UNPACKING INSTRUCTIONS

Unpack the ExaDigm GT unit and verify the following
1
components are enclosed for the GT:
If any items are missing, please contact ExaDigm at
2
866.392.8326 (option 4).
Attach the Cellular Antenna to the SMA connector on the
3
rear panel of the unit. Please make sure that the connector
is turned until there is resistance.
ttach the power supply connector to the "barrel" power
4 A
outlet on the rear panel of the unit and plug the power
supply into an AC power outlet. Verify that the green
POWER LED is illuminated. Allow 4 minutes after power is
applied for the unit to recognize and then connect to the
cellular network. When this has occurred, the Signal
Strength LEDs should light up from 1 to 3 LEDs. ExaDigm
recommends 2 bars or greater for robust operation of the
unit. If signal strength is showing 1 LED or showing the left
and right LEDs flashing (1 and 3 positions), please refer to
the User Manual at www.exadigm.com.
If the 3 RSSI LED lights do not illuminate – power off the GT for
1-5 seconds and replug the adapter.
Connect to the Ethernet RJ45 port for network connectivity.
5

ACCESSSING THE GRAPHICAL USER INTERFACE (GUI)

6 Connect PC to GT
The Ethernet Port on the GT is "auto-sensing", which
means a straight through or cross-over cable can be
used to connect to the ExaDigm router.
Connect a CAT-5 Ethernet cable between the local PC and
the unit's Ethernet port. Verify the link LED is lit.
Setup PC IP Address for DCHP
7
For assistance with configuring your PC, see the
appropriate Microsoft Windows support webpage listed
at: http://support.microsoft.com.
Technical Support Phone: 949.486-0320 (option 4) Toll Free: 866.392.8326 (option 4) Email:
• St. Louis, MO 63134-3100 • USA • +1 800 489 7781 • wireless.sales@Exadigm.com
POWER SUPPLY
©2013 ExaDigm Inc.
GT Cellular Gateway Router

Quick Start Guide

8 Access Graphical User Interface
Open a web browser and enter the following in the
Address bar:
http://192.168.12.20:8080/
You should see the following log-in prompt:
LOGIN INSTRUCTIONS
• User Name enter:
• For Password enter:
Note: It is important to change the password, which can be done
through the Administrator Settings tab on the System screen.
Select a strong password which contains a combination of
upper and lower case letters and at least one number or
symbol. The minimum is three characters and maximum 16.
Invalid characters are: space, \, % and '.
June 2013 version or newer - If a GTMS configuration download or
reset config is performed the password will be !ChangeMe!
Upon successfully logging in, you will see the following screen
You are now connected to the Management GUI. If you should
see anything other than the GUI screen shown, please refer
to the GT User Manual.
Confirm cellular network connectivity by clicking on the
9
"Cellular" tab on the left and the link to "Cellular Status".
You will see the following page with the current cellular
metrics provided.
www.Exadigm.com
root (lowercase letters)
(10-digit S/N)
support@exadigm.com
.