Signal Condition
Selects a channel and checks the signal condition.
A good Signal Strength is not an indication of suitable signal for DVB
reception.
Use the Signal Quality indicator as follows.
●
– Green bar: Good
– Yellow bar: Poor
– Red bar: Bad (Check the terrestrial aerial, cable or satellite dish.)
Vertical lines show the maximum signal value of the selected channel.
●
To change the channel
●
For DVB
●
Other settings
Favourite Network
Selects your favourite network for each broadcasters (only available in some
countries).
For DVB-C, DVB-T
●
Service Replacement
(On
/ Off)
Set to
On
to display a message to switch to the available service (only
available in some countries).
For DVB-C
●
Attenuator
(On
/ Off)
Sets the antenna system to use plural LNBs for receiving several satellites.
If the DVB-C signal is too strong, the interference may occur. In this case,
●
set to
On
to weaken the signal automatically.
Add TV Signal
Adds the TV mode.
This function is available if you skip any modes to tune in
●
first using the TV.
- 77 -
Auto Setup
for