Summary of Contents for CPAT FLEX DSG1
- Page 1 CPAT FLEX Operation Manual (DSG1) v 1.1 / 2014.06.12 © 2014 Effigis. All rights reserved. 006-000038-102...
- Page 2 Effigis assumes no responsibility for any omissions or errors that may appear in this document or for any dam- ages that may result from the use of information contained herein. DSG1 User Manual First edition (v1.1): June 2014 Part No. 5516...
-
Page 3: Table Of Contents
3. Installation ........9 3.1 Mounting the DSG1 in an Equipment Rack ....9 3.2 Connecting RF Outputs . - Page 4 B.2.6 Disclaimer ........22 CPAT FLEX (DSG1)
-
Page 5: General Information
1. General Information 1.1 About this Manual This manual describes the components, installation and operation of the CPAT FLEX DSG1 unit. You will find important safety information in this manual. We strongly recommend that all users read this manual. Use of this product other than for its intended application may com- promise the unit’s safety features. -
Page 6: Technical Support
Fax questions anytime to: + 1 514 495-4191 cpat@effigis.com 1.5 Calibration Your DSG1 unit has been calibrated and tested in the factory, and does not need further calibration before use. However, if the unit suffers damage and needs repair, it is recommended that the unit be returned to an authorized Effigis service center where it will be properly recalibrated. -
Page 7: System Components
2.2 Initial Verification Your DSG1 unit is calibrated and ready to use right out of the box. Upon reception, visually inspect each item for any damage that may have occurred during shipping. If you see any signs of physical damage, please contact Effigis: •... - Page 8 Figure 1: DSG1, rack mount brackets and AC/DC adapter If any of the standard accessories are lost or damaged, you can order a replacement for the DSG1. Please quote the following part numbers when placing an order: Part No. Accessory Description...
-
Page 9: Installation
3. Installation This section describes how to install the DSG1. You may also refer to the installation diagram at the end of this manual. 3.1 Mounting the DSG1 in an Equipment Rack CAUTION! Leave space for front, back and lateral ventilation. -
Page 10: Electrical Installation
When connected, the unit checks for new parameters or updates every 5 minutes. Transfers amount to a few hundred kilobytes per day. To ensure that the DSG1 can communicate with the CPAT FTP server and obtain its param- eters and update files, you must have the following: •... -
Page 11: Setup
4. Setup CAUTION! Any changes to the setup of the DSG1 carriers must also be made to the DRV3 receivers deployed on the field. Using different parameters will prevent the leakage detection from working as intended. The table below details parameters that can be set:... -
Page 12: Set Parameters Remotely
Once step “3.4 Internet Connection” has been completed, make sure that the unit has ac- cess to the Internet and that FTP port 21 is open. This is required in order for the DSG1 to communicate with the CPAT FTP server. -
Page 13: Using The Dsg1 Settings Applications
DSG1 units connected on the network. If several DSG1 units are found, the first DSG1 found is selected by default. To select a dif- ferent DSG1, choose another DSG1 from the dropdown menu next to the “DSG1” button. - Page 14 When a DSG1 is selected, the currently applied settings are summarized in the “Monitoring” panel. All “Lab volatile settings” functions become available for modification, if necessary. You can edit the attenuation, frequency and level of both bands within the allowed limits.
- Page 15 NOTE The DSG1 will always try to connect to the CPAT FTP server. If it succeeds, the DSG1 will download the active parameters file and overwrite the current one. To avoid this, do not connect the DSG1 to the Internet until the parameters have also been set on the CPAT database and stored on the FTP server.
-
Page 16: System Operation
IP address, but if there is no routing to the Internet, this message will be displayed. 5.3 Communication The DSG1 exchange files with the CPAT FTP server every 5 minutes. It looks for parameters file (less than 1 Kb). CPAT FLEX (DSG1) -
Page 17: Shutdown
5.4.2 Force Shutdown: To force the DSG1 to power down when it is running, press the ON/OFF button on the front panel for 3 seconds. When the unit has shut down, release the button. Use this shutdown method only if the normal shutdown method fails. -
Page 18: System Maintenance
6. System Maintenance 6.1 Cleaning the Equipment Your DSG1 unit can be wiped clean with a damp cloth. Do not immerse the unit in water. Avoid solvents and commercial cleaners. 6.2 Preventive Maintenance The technician shall perform periodic visual inspections on the RF connections to make sure that there is nothing loose or broken which could affect the performance of the system. -
Page 19: Appendix A - Specifications
+10 to 50 dBmV Status display Through an LCD on front panel Communication port 10/100Base-T Ethernet Setup Through CPAT interface Power 120 VAC, 0.5A (15W) fully loaded A.2 Physical Dimensions Standard 1RU chassis 4.4 cm x 21 cm x 33 cm / 1.75’’... -
Page 20: Appendix B - Our Services
Effigis Support. Effigis is not liable for any damage that may occur during shipping. The customer should clearly mark the Effigis’ issued RA or reference number on the outside of the package and ship it prepaid and insured to Effigis. CPAT FLEX (DSG1) -
Page 21: Limited Product Warranty
effigis.com Equipment repaired or replaced under warranty will be returned at Effigis’s expense to Cus- tomer (Canada/USA) or Effigis’ representative (all other countries). B.2 Limited Product Warranty B.2.1 Hardware Effigis warrants to the original end user (Customer) that the new Effigis branded products will be free from defects in workmanship and materials, under normal use, for one (1) year from the date of original shipment. -
Page 22: Refurbished Parts And Prior Testing
CLUDING, BUT NOT LIMITED TO, ANY WARRANTIES OR CONDITIONS OF MERCHANTABILITY, SATISFACTORY QUALITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT, REGARDLESS OF THE LEGAL THEORY ON WHICH SUCH IMPLIED WARRANTY MAY BE BASED, INCLUDING, WITHOUT LIMITATION, CONTRACT, COURSE OF DEALING, USAGE, OR TRADE PRACTICE. CPAT FLEX (DSG1) - Page 23 effigis.com Operation Manual...
- Page 24 effigis.com 1.888.495.6577...
Need help?
Do you have a question about the FLEX DSG1 and is the answer not in the manual?
Questions and answers