Summary of Contents for Home Advances Solar 6RHAS100LGR
-
Page 1: User Manual
Model 6RHAS100LGR Solar LED security light with motion sensor and built-in video camera USER MANUAL IMPORTANT ReAd ThIs eNTIRe MANuAl TO becOMe fAMIlIAR wITh The PROducT befORe use. fOR hOusehOld use ONly. -
Page 2: Features And Specifications
INTRODUCTION It is usually difficult for the average person to even consider installing an outdoor lighting and surveillance camera system – until now! This Solar LED security light with motion sensor and built-in video camera is designed to economically provide safety and security for your home. And, best of all, you can install it yourself by carefully following this manual. - Page 3 PARTS LIST + TOOLS REQUIRED AFteR un-pAckinG yOuR new SOLAR Led SecuRity LiGHt, cHeck tHe pROduct FOR dAmAGe And mAke SuRe tHAt yOu HAve ALL pARtS in tHe pARtS LiSt. iF yOu HAve Any pRObLemS witH tHiS pROduct, OR iF tHeRe ARe miSSinG OR dAmAGed pARtS, pLeASe cALL cuStOmeR SeRvice tOLL-FRee 1-800-459-4409 (mOndAy–FRidAy, 8:30Am–5pm, eSt).
- Page 4 LOCATION CHOICE FOR INSTALLATION cHOOSinG A LOcAtiOn FOR yOuR SOLAR Led SecuRity LiGHt FIG. 1 This Solar LED security light can be mounted on any solid surface, such as a wall. The detachable solar panel is attached to a 6.5 ft (2 m) power cord and can be mounted vertically or horizontally onto a solid surface that receives direct sunlight, such as a roof or wall.
- Page 5 When deciding where to mount the light, keep in mind that the passive infrared sensor (PIR) operates by detecting movement and heat. When the temperature of the moving object and its surrounding area are close in value, it may reduce the PIR’s sensitivity. The sensor will normally pick-up the movement of a person up to 16.5–26 ft (5–8 m) away when the outside temperature is 82°F (28°C) or less.
-
Page 6: Assembly & Installation
ASSEMBLY + INSTALLATION mOuntinG tHe SOLAR Led SecuRity LiGHt Follow the instructions in Fig. 5 to mount the Solar LED security light [01]. Place the Solar LED security light mounting bracket [02] in the location where you have chosen to install it. Using a pencil or felt tip marker, mark the placement of the three holes of the Solar LED security light mounting bracket [02] on the wall. -
Page 7: Mounting The Solar Panel
mOuntinG tHe SOLAR pAneL FIG. 6 If you are mounting the solar panel separate from the camera/light body, see Fig 6 for how solar panel to separate the solar panel from the Solar LED security light [01]. Unscrew the waterproof cover on the Solar LED security light and remove. -
Page 8: Charging The Battery
AdjuStinG tHe AnGLe OF tHe SOLAR Led SecuRity LiGHt The Solar LED security light/camera can be swiveled up and down, and left to right, according to your needs. To adjust it, first loosen the dial counterclockwise, then adjust the head. Then tighten the dial clockwise. See Fig. 8. FIG. -
Page 9: Video Recording And Playback
SettinG tHe dAte And time Follow these instructions to set the date and time that will be stamped on each video clip. Connect the Solar LED security light to your PC with a USB cable (not included). The SD card will now show as a removable hard drive. - Page 10 pRecAutiOnS wHen uSinG A Sd cARd FIG. 13 The SD memory card is equipped with a write-protect switch. Setting the switch to LOCK protects the existing data by prohibiting recording of new data, deletion of existing data or formatting of the card. A prompt will pop-up on the PC screen terminal when the card is write-protected.
-
Page 11: Troubleshooting
TROUBLESHOOTING Light will nOt switch on when there is movement in the detection area • Ensure that the power switch on the main body has been turned to the “ON” position. • Ensure that the motion sensor has been positioned to face movement. •... -
Page 12: Battery Replacement
BATTERY REPLACEMENT Follow the instructions in Fig. 14 to replace the battery. Unscrew the waterproof cover. Make sure the ON/OFF switch is in the “OFF” position. Carefully remove the old battery from its compartment. Replace with a new 1800 mAh Lithium rechargeable battery of same or greater capacity. Replace the waterproof cover and recharge the new battery in full, direct sunlight for four (4) sunny days. -
Page 13: Warranty Claim Procedure
WARRANTY This product is warranted to be free from defect in materials and workmanship under residential use for a period of one year from date of purchase. If the unit should fail to operate correctly, please call customer service at 1-800-459-4409 (Monday–Friday, 8:30 am–5:00 pm, EST) or contact us through our website at www.qualitycraft.com.
Need help?
Do you have a question about the 6RHAS100LGR and is the answer not in the manual?
Questions and answers