Advertisement
Table of Contents
- 1 Table of Contents
- 2 For Your Safety
- 3 General Information
- 4 Package Contents
- 5 Hardware Contents
- 6 Assembly Instructions
- 7 Operating Your Grill
- 8 Connecting & Disconnecting the Gas Cylinder
- 9 Checking for Leaks
- 10 Lighting Your Grill
- 11 Excess Flow Safety Valve Reset Procedure
- 12 Care and Maintenance
- 13 Troubleshooting
- 14 Warranty Program
- Download this manual
WARNING:
Improper installation,
adjustment, alteration, service
or maintenance can cause
injury or property damage.
Read the installation,
operation and maintenance
instructions thoroughly
before installing or servicing
this equipment.
DANGER:
Failure to follow these
instructions could result in
fire or explosion that could
cause property damage,
personal injury or death.
DANGER:
DO NOT use gas grill for
indoor cooking or heating.
TOXIC fumes can accumulate
and cause asphyxiation. DO
NOT use in or on boats or
recreational vehicles.
PROP 65 WARNING:
Chemicals known to the state
of California to cause cancer,
birth defects or other
reproductive harm are created
by the combustion of
propane.
WARNING:
FOR YOUR SAFETY:
For Outdoor Use Only
(outside any enclosure)
GSF2818KL
Owner's Manual
Outdoor LP Gas Barbecue Grill
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
IF YOU ARE ASSEMBLING THIS UNIT FOR SOMEONE ELSE,
GIVE THIS MANUAL TO HIM OR HER TO SAVE FOR FUTURE
REFERENCE.
FOR CUSTOMER SERVICE, EMAIL TO
SERVICE@BBQTEK.COM OR
CALL 1-877-885-8225 (TOLL-FREE), 07:00 A.M. – 16:00 P.M.
(EST), MONDAY-FRIDAY.
Service Center: 1-877-885-8225
0
MODEL# GSF2818KL
Advertisement
Table of Contents
Related Manuals for BHG GSF2818KL
Summary of Contents for BHG GSF2818KL
- Page 1 MODEL# GSF2818KL Outdoor LP Gas Barbecue Grill WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operation and maintenance instructions thoroughly before installing or servicing this equipment. DANGER: Failure to follow these...
- Page 2 NOTE: This grill must be used with propane gas only (propane gas cylinder not included). Installer: Leave this manual with the consumer. Consumer: Retain this manual for future reference. GSF2818KL Owner’s Manual...
-
Page 3: Table Of Contents
Fuel Gas Code, ANSI Z223.1/ NFPA54. Reference to Natural Gas and Propane Installation code CSA B149.1 or Propane Storage and Handling code B149.2 IMPORTANT NOTICE: READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY AND USE. Safety First! Read and understand all warnings and precautions prior to operating your grill. WARNING: GSF2818KL Owner’s Manual... - Page 4 Always confirm that the installation of this grill conforms with the requirements of all local codes or, in the absence of applicable local codes, with either the National Fuel Gas Code, ANSI Z223. NFPA 54 or CAN/CGA-B149.2. GSF2818KL Owner’s Manual...
-
Page 5: General Information
Step 3. Ensure that the valve nozzle is pointing straight and completely inserted into the venturi tube. General Information A propane gas cylinder is required for operation. This gas grill is NOT intended for commercial use. 3. Don't obstruct the ventilation opening of the cylinder enclosure. GSF2818KL Owner’s Manual... -
Page 6: Package Contents
SIDE KNOB SEAT CART LEFT SIDE PANEL SIDE KNOB GREASE CUP CART BACK PANEL GREASE CUP SUPPORT TANK CLIP CART RIGHT SIDE PANEL CART FRONT FRAME CART BOTTOM PLATE TANK SUPPORT LEFT DOOR SWIVEL CASTER RIGHT DOOR WARMING RACK GSF2818KL Owner’s Manual... -
Page 7: Hardware Contents
Screwdriver 1 PC M6 Nut 4 PCS M6 x 12 Bolt 4 PCS Wrench 1 PC Hardware listed above is not scaled to exact size. (A screwdriver is required on assembly and is included for your convenience). GSF2818KL Owner’s Manual... -
Page 8: Assembly Instructions
Insert one bolt (AA) with one spring washer (CC) and one flat washer (BB) into each pre-drilled holes. Tighten bolts by hand until secure. Repeat the procedure for the heat insulation panel and cart right side panel assembly. d) Tighten all bolts using the screwdriver provided. GSF2818KL Owner’s Manual... - Page 9 (X) and allowed 1/4 bolt’s length to extend from tank support. Hang the two pre-installed bolts on the hole of right side panel (V) and push them down to place. d) Go back and tighten all the bolts using screwdriver provided. GSF2818KL Owner’s Manual...
- Page 10 (BB) into each pre-drilled hole. Tighten bolts by hand until secured. a) Go back and tighten all bolts using the screwdriver provided. b) Repeat the procedure for the assembly of right side shelf (R) and side bar tool hanger. GSF2818KL Owner’s Manual...
- Page 11 (Q). (See the above diagram). d) Go back and tighten all bolts using the screwdriver provided. e) Place the side burner support (P) on the side burner assembly (Q), then close the side burner lid. GSF2818KL Owner’s Manual...
- Page 12 Conduct the leak test on page 14 to make certain all connections are connected securely. Step 15 (Rotisserie kit assembly. Option) a) Insert two forks (KD), balance block (KF) and roller (KE) into shaft (KC) in sequence. GSF2818KL Owner’s Manual...
- Page 13 Move the roller and put it into the slot on right side wall of the firebox. Tighten the screw on roller by hand. Note: Make certain the shaft will be not pulling out from the motor during operation. Fully Assembled View Left Side Right Side GSF2818KL Owner’s Manual...
-
Page 14: Operating Your Grill
9. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Install only the type of dust cap on cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. GSF2818KL Owner’s Manual... -
Page 15: Checking For Leaks
3. Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’ position. The burner should light immediately. If more than one burner is desired, repeat the procedure 2-3 until all desired burners are lit. 4. Adjust valve knob(s) to the desired cooking temperature. GSF2818KL Owner’s Manual... - Page 16 2. Keep the center line of GSF2818KL 3. Tighten the screw and make certain it is venturi tube and nozzle Owner’s Manual secured.
-
Page 17: Excess Flow Safety Valve Reset Procedure
After the first front burner is lit, turn on the other control knob(s) to the HIGH position. If you have more than two burners, turn them on only ONE AT A TIME. When all front burners are lit, close the grill lid. Wait for 10-15 minutes; the temperature should reach 400 – 450°F. GSF2818KL Owner’s Manual... -
Page 18: Care And Maintenance
Remove burner by unscrewing nut from beneath burner “foot” using a screwdriver and pliers. Lift burner up and away from the gas valve orifice. Clean inlet (venturi tube) of burner with small bottle brush or compressed air. Remove all food residue and dirt on outside of burner surface. GSF2818KL Owner’s Manual... -
Page 19: Troubleshooting
Turn front of grill to face wind or High or gusting winds. Flame blow out. Increase flame height. Replace or refill propane tank. Low on propane gas. Refer to the Excessive flow safety Excess flow valve tripped. valve reset procedure on page 16. GSF2818KL Owner’s Manual... -
Page 20: Warranty Program
1-877-885-8225, 07:00 A.M. to 16:00 P.M. (EST), Monday through Friday. Manufactured by: Lucas BBQ Co., Ltd. Liangbian Industrial Zone, Liaobu Town, Dong Guan City, Guang Dong, China. Printed in China GSF2818KL Owner’s Manual...
Need help?
Do you have a question about the GSF2818KL and is the answer not in the manual?
Questions and answers