Battery Installation - iHome2GO iHM1 Instruction Manual

� �
�
�

Battery Installation

New 2g iPod nano
NOTE:
FOR BEST SOUND,
turn Sound Check ON
in your iPod Settings
menu
NOTE: ADJUST iPod
VOLUME TO AVOID
DISTORTION
Release Button
Power Indicator
NOTE: UNIT DOES NOT CHARGE iPod nano
� �
Mode Button
iPod nano switch
Using the iHM1
Thank you for purchasing the iHM1, the speaker system for
your iPod nano. Designed specifically to work with your iPod
nano, this system provides high quality audio and that invites
your music to come out and play.
Please read the instructions carefully before operating the
unit and keep for future reference.
Installing/Replacing Batteries
1. Open the battery compartment cover located on the back
of the unit.
2. Insert 3 "AA" (LR6) batteries, checking that the + and –
ends of the batteries match the drawing inside the battery
compartment. We recommend the use of alkaline
batteries for longer life.
3. Close the compartment cover.
Battery information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable batteries.
• Make sure you dispose of batteries properly (see your
local regulations).
iPod nano switch (located on bottom of unit):
• Default setting is for the new 2g iPod nano.
• If you have an original 1g iPod nano, slide the switch to
the left position.
Inserting/Removing iPod nano from the unit
1. Slide your iPod nano into the unit as shown. Please make
sure the iPod nano is fully docked into the unit before
turning on power on the unit.
2. To remove your iPod nano, push the "Release" button
down. The iPod nano will pop up and you can tilt it into
the palm of your hand.
Listening to your iHM1
1. Turn on your iPod nano and set desired volume.
2. Switch the mode button located on the right side of the
unit to On or to SRS TruBass if you want more bass.
3. Because audio tracks are mastered differently, you may
notice discrepancies in volume from song to song.
For best sound, turn Sound Check ON in your nano's
Settings menu.
4. Remember to turn unit OFF when not in use to save
batteries. To extend battery life, play unit without SRS
TruBass feature.
Maintenance
• Place the unit away from sources of direct sunlight or
excessive heat.
• Protect your furniture when placing your unit on a natural
wood and lacquered finish.
• Clean your unit with a soft cloth moistened only with mild
soap and water. Stronger cleaning agents, such as
Benzine, thinner or similar materials can mar the surface
of the case.