Quick Start - iHome 2GO Cycler iH85 User Manual

iH85 Quick Start
1:Opening and Closing
1
1. Twist the top half of the case as shown
2. Lift off.
When the case is open, you can change batteries
and access (dock and undock) your iPod.
To close the case, place case halves together and
twist until arrows align.
Your iH85 comes
with 3 inserts to
ensure your iPod fits
properly in the dock.
Note: Thick iPod
models dock without
insert
3:Docking a Thin
iPod
1
1. Gently slide the Thin iPod insert
into the dock.
2. Carefully place your iPod onto the
dock connector. The iPod must
not be in a case or "skin".
2
Mini Insert
Thin iPod Insert
Use with iPod 4G
iPod Mini iPod Photo
5G iPod w/ Video
4:Docking a Nano
or iPod Mini
2
1
2
1. Gently guide the nano or mini onto
the connector pins in the dock
2. Slide the nano insert over the
docked nano OR the mini insert
over the docked mini
2:Power: AC or Batteries
To charge and play iPod, attach AC adaptor to jack at
waist of the iH85 (under rubber tab) and plug the other
end into a working AC outlet. Does not charge batteries.
For portable operation (on bike, etc.), open the battery
door located inside the unit behind the iPod dock.
Install 4 AA batteries (match + and - polarity in diagram).
Thick iPod
(no Insert needed)
20 GB
iPod 4G
20/30 GB
iPod Photo
30 GB
5G iPod w/ Video
2
RESET R
SET E
TEST T
ST E
Nano Insert
40 GB
iPod Nano
60 GB
2/4/8 GB
60/80 GB
5:Playing iPod
1
2
Insert iPod into dock with proper insert
as needed. When running on AC
power, the iPod will charge while
docked. Press the Power Button on
the iH85 to play iPod.