Do you have a question about the mini PhotoScanner and is the answer not in the manual?
Questions and answers
Noel Keast
May 23, 2025
Red light Flashing
1 comments:
Mr. Anderson
May 25, 2025
A flashing red light on the Kaiser Baas mini PhotoScanner indicates that no scan is possible. This may be due to the SD card not being inserted properly, the SD card being locked or write-protected, the memory card being full (less than 1MB free space), or an incorrect file format (must be FAT or FAT32, not NTFS).
PhotoScanner Contents Introduction Features Safety Product Specifications Package Contents Product Description Using the mini PhotoScanner Connecting to a PC Maintenance Troubleshooting mini PhotoScanner User Manual...
PhotoScanner Introduction Congratulations on the purchase of your Kaiser Baas mini PhotoScanner. Please take a few minutes to read through this user guide, which will provide instructions for you to install, operate and maintain the product. Features • Auto-feed design •...
Do not try and disassemble or remodel the Kaiser Baas mini PhotoScanner Doing so may cause the unit to malfunction and may void the warranty • Do not place the Kaiser Baas mini PhotoScanner in places that are exposed to oil, water or dust •...
PhotoScanner Package Contents • 1 x Kaiser Baas mini PhotoScanner • 1 x Software CD • 1 x Power adaptor • 1 x Calibration card • 1 x USB cable • 1 x Quick start guide • 1 x Roller cleaning tool •...
PhotoScanner Product Description Power on /off button Power input Calibration/cleaning button Mini USB connector Guide lever Memory stick slot Feeding slot SD card slot 5VDC To PC SD / MMC 5VDC To PC SD / MMC mini PhotoScanner User Manual...
Insert the photo into the sleeve as shown below – When feeding the protected photo into the mini PhotoScanner, make sure the sealed end goes in first to avoid jamming the auto loading.
Page 8
For example Scan0001, Scan0002, etc. When you have finished scanning, press and hold the power button for 2 seconds to turn off the mini PhotoScanner. You can now safely disconnect the power and remove the SD card or USB memory stick from the scanner.
Page 9
PhotoScanner LED light status Green on – The scanner is ready to use Green blinks continuously – Initialising system and memory card/ USB memory stick / Busy scanning and storing images / Sensor cleaning in progress Two blinks –...
PhotoScanner Connecting to a PC By connecting the mini PhotoScanner to the PC, you can access the scanned images on the SD card directly, or you scan directly to the hard drive. Insert the provided CD into the PC and install the ‘Scan To PC’ software.
PhotoScanner Maintenance Cleaning the roller With an SD card or USB memory stick inserted, press and hold the power button for 0.5 seconds to turn on the scanner Place the supplied roller cleaning tool into the feed slot The cleaning tool will be feed...
PhotoScanner Troubleshooting Q. There are lines on the scanned image or the image is not clear A. Check the following – Are there scratches on the original print? Remove any stains or dust before scanning Has the scanner been used for a long period of time without cleaning or...
Need help?
Do you have a question about the mini PhotoScanner and is the answer not in the manual?
Questions and answers
Red light Flashing
A flashing red light on the Kaiser Baas mini PhotoScanner indicates that no scan is possible. This may be due to the SD card not being inserted properly, the SD card being locked or write-protected, the memory card being full (less than 1MB free space), or an incorrect file format (must be FAT or FAT32, not NTFS).
This answer is automatically generated