Troubleshooting - Philips HTB3520 User Manual

• Speaker drivers: 2 x 78 mm (3") full range
• Dimensions (WxHxD):
314 x 103 x 94 mm
• Weight: 0.97 kg
• Cable length: 2 m
Front/Rear speaker:
• Output power:
4 x 166 W RMS (10% THD)
• Speaker impedance: 3 ohm
• Speaker drivers:
HTB3520: 78 mm (3") full range
•
(front/rear)
• HTB3550:
2 x 78 mm (3") full range (front);
78 mm (3") full range (rear)
HTB3580: 2 x 78 mm (3") full range
•
(front/rear)
• Dimensions (WxHxD):
HTB3520: 100 x 193 x 125 mm
•
(front/rear)
HTB3550:
•
250 x 1140 x 250 mm (front);
100 x 193 x 125 mm (rear)
HTB3580: 250 x 1140 x 250 mm
•
(front/rear)
• Weight:
HTB3520: 0.65 kg/each (front/rear)
•
HTB3550: 3.86 kg/each (front);
•
0.65 kg/each (rear)
• HTB3580: 3.86 kg/each (front/rear)
• Cable length (front): 3 m
• Cable length (rear): 10 m
Remote control batteries
• 2 x AAA-R03-1.5 V
Laser
• Laser Type (Diode): InGaN/AIGaN (BD),
AIGaInP (DVD/CD)
• Wave length: 405 +7 nm/-7 nm (BD),
655 +10 nm/-10 nm (DVD),
790 +10 nm/-20 nm (CD)
• Output power (Max. ratings):
20 mW (BD), 6 mW (DVD), 7 mW (CD)
32 EN

8 Troubleshooting

Warning
•
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at
www.philips.com/support.
Main unit
The buttons on the home theater do not
work.
• Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
• Make sure that the touch buttons surface
is not in contact with any conductive
material, like water drop, metal, etc.
Picture
No picture.
• Make sure that the TV is switched to the
correct source for the home theater.
No picture on a TV connected through HDMI.
• Make sure that you use a High Speed
HDMI cable to connect the home theater
and TV. Some Standard HDMI cables do
not display properly for some images, 3D
video, or Deep Color.
• Make sure that the HDMI cable is not
faulty. If it is faulty, replace it with a new
cable.
(Home) and then 731 on the
• Press
remote control to restore the default
picture resolution.
• Change the HDMI video setting, or wait
for 10 seconds for auto recovery (see
'Picture and video settings' on page 25).