Network Settings; Network Type; Wired Installation; Wireless Settings - Philips PFL60x7D User Manual

7 NETWORK
SETTINGS
(For certain models only)
You can confi gure the network in order to access
different networks.

Network Type

You can select the type of network setup.
1
Press (Home).
2
Select [Setup] > [TV settings] > [Network
[Network type]
settings] >
3
Select [Wired]

Wired Installation

To connect the TV to the computer network, you
need to install a router in your computer network.
Use an Ethernet cable to connect the router to
the TV.
Use a network cable to connect the router to the
network interface on the side of the TV, and switch
on the router before installing the network.
Wired network settings - Automatic
search
1
Press (Home).
2
Select [Setup] > [TV settings] > [Network
[Network mode]
settings] >
3
[DHCP & Auto IP] and then press
Select
OK.
» The network protocol will be set up
automatically.
X41G39MV-813-01A 9 50 55PFL5820_GB_20120709.indd 23 X41G39MV-813-01A 9 50 55PFL5820_GB_20120709.indd 23
.
or [Wireless]
.
.
Wired network settings - Manual
entry
1
Press (Home).
2
Select [Setup] > [TV settings] > [Network
[Network mode]
settings] >
3
[Static IP] and then press
Select
» The [IP confi guration] option appears.
4
[IP
Select confi guration
numeric buttons to enter the [IP
address], [Netmask], [Gateway], [DNS
1] and [DNS 2] confi gurations.
5
After completing the entry,
.
and then press OK

Wireless Installation

For certain models only.
To connect the TV to the wireless network, you
need to insert the wireless network adapter
(supplied with certain models only) into the USB1
to USB3 ports on the side of the TV.

Wireless settings

1
Press (Home).
2
Select [Setup] > [TV settings] > [Network
[Network type] > [Wireless]
settings] >
3
Select [Setup] > [TV settings] > [Network
[Wireless Setting]
settings] >
4
Select [Scan].
5
Select your computer network.
» You are prompted to enter your
computer network ID.
6
Press OK to begin entering the ID with the
onscreen keyboard.
7
Select each character, then press OK to
enter the character. Repeat until the ID is
complete.
8
When the ID is complete, select [Done] on
the keyboard, then press OK.
9
Select [Done], then press OK.
» A confi rmation message is displayed.
10
Select [Close], then press OK.
.
OK.
] and use the
select [Done]
.
.
EN-GB 23
8/27/2012 11:08:49 AM 8/27/2012 11:08:49 AM