Bosch Tumble Dryer Instructions For Installation And Use Manual page 2

Installation Technical data
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
1. Take all accessory parts
– The appliance plug must always be accessible. out of the drum.
The drum must be empty.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
Clean and level
Make sure that the air
inlet remains unobstructed
2. Mains connection see safety instructions Page 11.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate ( Page 9) must correspond.
– The connected load and necessary fuse protection are specified on the rating plate.
Do not operate the dryer if
Frost protection / Transport
there is a danger of frost.
Preparation
Optional accessories
1. Empty the condensation container page 4.
2. Select any programme using the programme selector.
WTZ
3. Press the Start/Stop button condensation is pumped into the container.
1110
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
WTZ
11310
WTZ
10290
7 8
What to do if ...
Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable)
If you cannot rectify a fault yourself, please contact our after-sales service. We will always find
an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
Weight approximately 45 kg
the manufacturer and rest assured that the repair will be carried out by trained service
Max. capacity 8 kg
technicians using original spare parts. The contact details of your local after-sales service can
be found in the enclosed after-sales service directory, or by calling one of these numbers:
Condensation container 4.2 l
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
Connection voltage
A call set-up fee of up to 6 pence may apply.)
Connected load
– IE 01450 2655
Fuse protection see appliance rating plate When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see the inside of the door).
Ambient temperature
Set the programme selector to Off and remove the appliance plug from the socket.
Product number/
The Start/Stop indicator
Production number
lamp does not light up.
You can find the rating plate on the back of the dryer. The Container and
Consumption rates These are guide values determined under standard Start/Stop indicator lights are
flashing.
conditions. Fluctuations up to 10% are possible.
Spin speed in rpm Drying time Energy The Filter and
(residual moisture) in min.** consumption indicator lights are flashing.
in kWh**
Dryer does not start.
Cottons 8 kg 10 A 10 A
Cupboard Dry .* 1400 (approx. 50 %) 131 3.74
1000 (approx. 60 %) 148 4.49
Water is running out.
800 (approx. 70 %) 165 5.17
Iron Dry * 1400 (approx. 50 %) 109 2.24
The door opens by itself.
1000 (approx. 60 %) 126 3.44
The required degree of
800 (approx. 70 %) 143 3.86
dryness was not achieved or
Easy-Care 3.5 kg 1000 45 1.05
the drying time was too long.
Cupboard Dry .* 800 (approx. 40 %) 48 1.35
600 (approx. 50 %) 60 1.65
*Test program according to DIN EN 61121.
**The values may differ from the those specified depending on the type of fabric, mixture of
laundry to be dried, residual moisture in the fabric and loading capacity.
Drum interior light (depending on model) (bulb E14, 25 W)
The drum is illuminated after the door is opened or closed, and also after the programme is
started. It goes out automatically. Replacing the bulb Page 10.
Laundry damp.
(order from the after-sales service using the order number)
Connection fittings for condensation outlet The moisture content of the room
The condensation is conveyed directly via a hose.
has increased significantly.
Washer-dryer stack connection set
Mains failure.
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. This connection set must always be used to secure the dryer to the washing
One or more indicator lights for
machine. With pull-out worktop: WTZ 11300.
programme status are
Installation underneath the worktop
flashing.
Risk of electric shock!
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
The interior light is not working
(depending on model).
9
Safety instructions
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
Emergency
ONLY use the – In rooms inside the house.
dryer...
– To dry fabrics.
The dryer must – Be used for other purposes than those described above.
NEVER...
– Be modified in terms of its technology or attributes.
Dangers – The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets.
Mains plug plugged in? Make especially sure that cigarette lighters are removed as they constitute an
Programme selected? explosion hazard.
– Do not lean or sit on the door
Empty the condensation container.
If featured, check hose for condensation outlet. Installation – Secure loose cables
– Do not operate the dryer if there is a risk of frost.
Clean the fluff filter and/or air cooler under running water Mains – Connect the dryer according to specifications to an AC earthed socket, as
Start/Stop
Page 4/6. connection otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
Start/Stop button selected?
– Only use earth-leakage circuit breakers with the following symbol:
Door closed?
– The appliance plug and socket must be compatible.
Programme set?
Ambient temperature greater than 5 °C? – Do not use multiple plugs/couplings and/or extension cables.
– Do not hold the appliance plug with wet hands
Align dryer horizontally.
– Never pull the appliance plug out of the socket by its cable.
Clean air cooler seal.
– Do not damage the mains lead
Push the door closed until you hear it engage.
– Only load the drum with laundry.
Operation
Clean the fluff filter and/or air cooler under running water Check the contents before you switch the dryer on.
Page 4/6. – Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Empty condensation container Page 4. grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.)
Check water outlet (if featured).
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
Ambient temperature higher than 35 °C airing.
explosion hazard.
Air inlet may be blocked keep unobstructed.
– Do not put laundry containing foamed material/rubber in the dryer
Was an unsuitable programme selected? Page 7.
material may be destroyed and the dryer may be damaged due to possible
Has the dryer been installed with sufficient space on all
deformation of the foamed material.
sides? Ensure that air can circulate.
– Switch off the dryer once the programme has ended.
Fine layer of scale on the moisture sensors Clean the
– Condensation is not drinking water and may be contaminated with fluff.
moisture sensors page 6.
Defect – Do not use the dryer if it is defective or if you suspect it is.
Use the next drying programme up or use the timer
Repairs must only be carried out by the after-sales service.
programme as a supplement Page 7.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
Warm laundry feels damper than it really is!
have the defective mains cable replaced by the after-sales service.
Make sure the room is sufficiently ventilated.
– Always pull the mains plug out of the socket before changing the bulb for the
Air inlet blocked? keep unobstructed.
interior light risk of electric shock.
Ensure that the air cooler has been inserted.
Spare parts – Only use genuine spare parts and accessories for safety reasons.
Remove laundry from the dryer immediately and spread out.
Disposal – Dryer: pull out the appliance plug, then cut off the mains cable from the
This allows the heat to dissipate.
appliance.
Clean filter and air cooler Page 4/6. Dispose of at municipal waste disposal facility.
Check installation conditions Page 8. – Packaging: do not leave children alone with packing parts
Switch off, leave to cool down, switch on again, restart risk of suffocation.
programme. – All materials are environmentally sound and can be reused. Dispose of in an
environmentally-responsible manner.
Pull out the appliance plug, remove the cover cap in the
interior above the door (use Torx 20 screw driver) and
replace the bulb. Close the cover cap.
Never operate the dryer without a cover cap.
10
risk of tipping.
tripping hazard.
Tumble dryer
risk of electric shock.
risk of electric shock.
fire/explosion hazard.
Instructions for
installation and use
elastic
Observe the safety instructions on page 11.
Read these instructions before operating the dryer.
11
en