Panasonic Lumix DMC-FZ18P Service Manual page 19

Group Main item
SOFT CPU
Card
CPU, VENUS
hard
Operation
Zoom
About "*" indication in the above table:
The third digit from the left is different as follows.
- In case of 0 (example: 18001000)
When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has been
completed.
It means that this error is occurred basically at user side.
- In case of 8 (example: 18801000)
When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has been
released.
(Example; Factory assembling-line before unit shipment, Service mode etc.)
It means that this error is occurred at service side.
• 6. How to returned to Normal Display:
Turn the power off and on, to exit from Error code display mode.
NOTE:
The error code can not be initialized.
Sub item Error code
Upper 4 bits Low 4 bits
Reset 30*0
Card 31*0
39*0
Stop 38*0
Power on 3B*0
Zoom 3C*0
35*0
35*1
35*2
Remedy/Check point (Lower frame)
0001 NMI reset
I Non Mask-able Interrupt
0007 (30000001-30000007 are caused by factors)
0001 Card logic error
SD card data line or IC6001 (VENUS 3)
0002 Card physical error
SD card data line or IC6001 (VENUS 3)
0004 Write error
SD card data line or IC6001 (VENUS 3)
0005 Format error
SD card data line or IC6001 (VENUS 3)
0001 Camera task finish process time out.
Communication between Lens system and IC6001 (VENUS 3)
0002 Camera task invalid code error.
IC6001 (VENUS 3)
0100 File time out error in recording motion image
IC6001 (VENUS 3)
0200 File data send error in recording motion image
IC6001 (VENUS 3)
0300 Single or burst recording brake time out.
0000 FLASHROM processing early period of camera during movement.
0000 Zoom lens processing is incomplete.
Zoom lens, IC7001
0000 When "BKI" and/or "WKI" adjustment is perfomed,
this code may be registered by chance.
No remedy is required.
0000 Software sequence error.
Connector is unlocked. /Flex cable is damaged.
0000 Software sequence error.
Connector is unlocked. /Flex cable is damaged.
19
Error Description (Upper frame)