Mitsubishi Electric MFZ-KA25VA Operating Instructions Manual page 6

● OPERATING INSTRUCTIONS ●
F
AN SPEED AND
AIRFLOW DIRECTION ADJUSTMENT
Press to select fan speed. Each press will
change fan speed in the following order:
(AUTO) (Low)
• Two short beeps will be heard from the indoor unit when set to AUTO.
Press to select vertical airfl ow direction. Each
press will change airfl ow direction in the following
order:
(AUTO) (1) (2)
• Two short beeps will be heard from the indoor unit when set to AUTO.
• Moving the horizontal vane manually can cause trouble.
• The horizontal vane automatically moves in certain intervals to deter-
mine its position, and then it returns to the set position.
Airflow direction
(AUTO) . ......The vane will be set to the most effi cient airfl ow direction.
COOL/DRY : position (1)
HEAT (upper and lower air outlets) : position (3)
HEAT (upper air outlet only) : position (5)
(Manual) . ....For efficient air conditioning, select upper position for COOL/
DRY, and lower position for HEAT. During COOL/DRY, when
the vane is set to position (3), (4), or (5), the vane automati-
cally moves to position (1) after 0.5 to 1 hour to prevent water
dripping.
(Swing) . ......The vane will move up and down intermittently.
■ To change the horizontal airfl ow direction.
Move the vertical vane manually before starting operation.
Always adjust the vane when the damper is open. Opening the damper forcibly
with hands can cause damage or malfunction.
En-5
(Med.) (High) (Super High)
(3) (4) (5) (SWING)
A
IR OUTLET SELECTION
Select to blow air from the upper
and lower air outlets.
Air will blow only from the upper outlet in the following conditions:
• During COOL: When the room temperature is close to set tempera-
ture. When the air conditioner has operated for 1 hour.
• During DRY operation.
• During HEAT: When the air flow temperature is low.
(During defrosting operation, start of operation, etc.)
Select to blow air from the upper air
outlet only.
Note:
Be sure to keep the area around the damper of the lower air outlet free of any
objects. If any objects block the normal operation of the damper, the left opera-
tion indicator lamp may blink.
Set the air outlet selection switch to the end. Otherwise, air outlet cannot be
selected as intended.