Update Software Through The Internet; Update The Onscreen Help - Philips HTS5563 User Manual

Update software through the
Internet
1
Connect your home theater to a home
network with a high-speed Internet access
(see 'Connect and set up a home network'
on page 14).
2
Press (Home).
3
Select [Setup], and then press OK.
4
Select [Advanced] > [Software update] >
[Network].
» If an upgrade media is detected, you are
prompted to start or cancel the update.
5
Follow the onscreen instructions to confirm
the update.
» Once complete, the home theater
automatically switches off and restarts. If
it does not, disconnect the power cord
for a few seconds and then reconnect it.

Update the onscreen help

If the current version of the onscreen help is
lower than the latest version available on www.
philips.com/support, download and install the latest
onscreen help (see 'Check software version' on
page 29).
What you need
•
A USB flash drive that is FAT or NTFS-
formatted, with at least 35MB of memory. Do
not use a USB hard drive.
•
A computer with internet access.
•
An archive utility that supports the ZIP file
format.
EN
30
Step 1: Download the latest onscreen
help
1
Connect a USB flash drive to your computer.
2
In your web browser, go to www.philips.com/
support.
3
At the Philips support website, find your
product and click on User manuals, and then
locate the User Manual Upgrade Software.
» The help update is available as a zip file.
4
Save the zip file in the root directory of your
USB flash drive.
5
Use the archive utility to extract the help
update file in the root directory.
» A file named 'HTSxxxxeDFU.zip' is
extracted under the UPG_ALL folder
of your USB flash drive, 'xxxx' being the
model number of your home theater.
6
Disconnect the USB flash drive from your
computer.
Step 2: Update onscreen help
Caution
•
Do not switch off the home theater or remove
the USB flash drive during the update.
1
Connect the USB flash drive containing the
downloaded file to your home theater.
•
Make sure that the disc compartment is
closed and there is no disc inside.
2
Press (Home).
3
Enter 338 on the remote control.
4
Follow the onscreen instructions to confirm
the update.
5
Disconnect the USB flash drive from the
home theater.