Stand Installation - Hyundai H-LCD901 Instruction Manual

Instruction manual
Battery installation
Insert the battery according to the picture
above, observing the correct polarities (+) and
(-). Use one Cr2025 size battery. If the RC fails
to work even operated near the unit, replace
the battery. Do not use rechargeable batteries.
Remove the battery when the RC will not be in
use for a long time.
Button functions
POWER/ button: Press this button to
turn on or off the unit.
MENU/ button: Press this button to
display the on-screen menu.
AV/TV / button: Press this button to
switch between video sources.
MUTE/ button: Press this button, sound
disappears; press it again or press VOL+/VOL-
or / buttons to resume a normal sound.
When sound is muted, a corresponding symbol
appears on the display.
VOL-/VOL+ /
button, the volume of TV set decreases.
Press VOL+/ button, the volume of TV set
increases.
CH+/CH- / / buttons: Press CH+/
button, the number of TV channel increases.
Press CH-/ button, the number of TV
channel decreases.
Number buttons
When the channel is a one-digit figure, just
press the corresponding number button. If
4
buttons: Press VOL-/
~ and button:
the channel is a two-digit figure, you should
press button first to show - - on the
display screen before further pressing the
corresponding number buttons.
MODE/ button: Press this button to
select picture mode.
Installation and connection

Stand installation:

Release the metal washer on the top of the
bracket but do not separate it from the bracket.
Insert the metal washer with the bracket into
a hollow at the back of the unit and move the
bracket up to a suitable height.
Tighten the screw 1 up on the bracket to fix
the stand with the unit.
Control the screen angle with the lateral
screw.
Screw the stand to the bracket.
Connection of the antenna:
Plug the antenna into the Antenna jack
situated on the rear panel of the unit.
Connection of headphone:
Connect the headphone to the headphone
jack for private listening. The speakers will not
operate when headphones are connected.
Connection to power source:
Connect one round end of attached AC/DC
adaptor or car adaptor to the power source
input jack and the other end to the wall outlet
at the suitable voltage. When in house, use the
AC/DC adaptor; for car use, connect with the
car adaptor (adaptors included should be only
used). Press POWER/
the unit.
AV input connection
Connect the AV cable as showed in the
picture below. After connection, switch the unit
to the AV mode.
button to turn on