Subscribe to Our Youtube Channel
Summary of Contents for Electro-Tech systems 5473 Series
- Page 1 Thermoelectric Cooling System Model 5473 – 1 150W (510 BTU/hr.) 1 200W (680 BTU/hr) 1 300W (1020 BTU/hr) 1 400W (1360 BTU/hr) Operating Manual 7/07/06 www.electrotechsystems.com...
- Page 2 Table of Contents 1.0 GENERAL 2.0 COOLING SYSTEM SET-UP 3.0 INSTALLATION 4.0 SPECIFICATIONS AND PERFORMANCE WARRANTY...
- Page 3 OPERATING INSTRUCTIONS 1.0 GENERAL The Model 5473 Series of solid state, thermoelectric cooling systems, shown in Figure 1.0-1, utilize the Peltier effect to reduce the temperature of a large heat sink. One or more 110 cfm fans circulate the air within a sealed chamber through the heat sink to continuously reduce the temperature.
- Page 4 These systems are best suited for maintaining precise ambient temperatures inside an enclosed chamber. For an uninsulated, 15 cu. ft. chamber, fabricated from 0.375” (10 mm) acrylic, these coolers can reduce the temperature by 5, 10 and 18 °F (3, 5 and 10 °C) respectively. Heat load, insulation and chamber size will ultimately determine the level of cooling that can be obtained.
- Page 5 2. Set the Temperature Controller set-point to a value below the ambient temperature (Refer to Controller Operation in the respective Controller Operating Manual). When the microprocessor tells the Cooler to activate, the red LED on the Microprocessor will light. Inside the chamber, the thermoelectric cooler will begin to cool and the fans will begin moving.
- Page 6 WARRANTY Electro-Tech Systems, Inc. warrants its equipment, accessories and parts of its manufacture to be and remain free from defects in material and workmanship for a period of one (1) year from date of invoice and will, at the discretion of Seller, either replace or repair without charge, F.O.B.
Need help?
Do you have a question about the 5473 Series and is the answer not in the manual?
Questions and answers