Connect Your Monitor & Audio; Initial Power On - Wired MasonIP User Manual

Connect Your Monitor & Audio
5. Connect your TV monitor(s) to the desired output(s).
You can connect more than one video output if you like, but depending
on the resolution you select some will not be active.
If your monitor has a
HDMI input, you can
connect it to the DVI
output of the Mason
using an HDMI-to-
DVI adapter
(not included).
6. Connect the desired audio output(s) to your sound system/amplifier. All
audio outputs are active at all times, so you can connect them to differ-
ent devices as needed.

Initial Power On

7. Turn on your TV monitor, then turn on the Masonʼs power switch (on the
rear panel.) After a few moments you should see the main Mason menu
on your TV. If you donʼt see anything, make check to be sure your TV
is set to the correct input. The Mason is configured at the factory with
these video settings:
Analog video.........
Digital Video.........
If your monitor cannot operate at the default resolution, you can cycle
through a variety of SD and HD output resolutions by pressing the ʻTV
Modeʼ button on the remote control. Each time you press the button
the Mason will change to a different mode. Continue until you find one
that works on your monitor.
Mason User Guide
480i (NTSC)
480P
Jan 2008 9 of 27