Table of Contents
Advertisement
< Auto-Configuration Network Setup>
The default setting of the WVPS box is DHCP client. When the box is connected to a LAN that already has a DHCP server present,
the WVPS box takes an IP address assigned to it by the server. When the WVPS box is connected to a LAN that does not have a
DHCP server, the WVPS box becomes the DHCP server in the network.
< IP Setup>
Select "Obtain IP address automatically" or "Use the following IP address."
• IP Address: The default value is 192.168.100.10.
• Subnet Mask: The default value is 255.255.255.0.
• Default Gateway: The default value is 192.168.100.10.
<DHCP Server Setup>
• Select auto (Enable/Disable DHCP Server) or Disable.
• Start IP: The start IP address of DHCP Server.
• End IP: The end IP address of DHCP Server.
< Wireless Setup>
• Region: Default value is "Worldwide."
• SSID: SSID string. Maximum length is 32 bytes.
• Channel: You can set a fixed channel or choose Auto. If you select "Auto," after you power on the WVPS, it will scan all wire-
less channels and select a clear channel automatically.
• WEP: You can click Disable WEP key or select 64 bit or 128 bit in ASCII or HEX string.
• Key: If WEP is enabled, set the key value according to the WEP mode you selected.
< Gatekeeper>
Gatekeeper ensures network security within the WVPS box.
• All Block can block Guest Users (through wireless) from accessing all office networks (LANs).
• All Allow can pass Guest Users (through wireless) to access all office networks.
• Internet Only can block Guest Users (through wireless) from an office network (LAN) but still reserve internet connection
capability.
<Apply >: Press button to select this mode.
<Cancel>: Press button to abort action.
<Back>: Back to Operating mode main menu.
Chapter 6: Web Management
Page 35
Advertisement
Table of Contents
