Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for extronics iCAM100
- Page 1 INSTALLATION AND OPERATING MANUAL iCAM100...
- Page 2 Document Number 405214 (See Last Page for Revision Details) For warranty information, refer to Terms and Conditions at http://www.extronics.com © 2014 Extronics Limited. This document is Copyright Extronics limited. Extronics reserve the right to change this manual and its contents without notice, the latest version applies.
-
Page 3: Table Of Contents
Installation and Operating Manual Contents Introduction ....................4 Safety Information and Notes ................5 Storage of this Manual ................5 Special Conditions for Safe Use ..............5 2.2.1 ATEX ....................... 5 List of Notes ..................... 6 Installation ..................... 7 Wiring ...................... -
Page 4: Introduction
It is also ideal for monitoring plant or areas which are difficult to view due to its compact size. The iCAM100’s design means that it is suitable for use in both Zone 1 /21 and Zone 2/22 environments. -
Page 5: Safety Information And Notes
Installation and Operating Manual 2 Safety Information and Notes 2.1 Storage of this Manual Keep this user manual safe and in the vicinity of the device. All persons required to work on or with the device should be advised on where the manual is stored. -
Page 6: List Of Notes
Warning! The iCAM100 enclosure is not to be opened if the camera is live; wait 1 minute after de-energising before opening. Warning! The iCAM100 enclosure is not to be opened if an explosive atmosphere is present. -
Page 7: Installation
Installation and Operating Manual 3 Installation The iCAM100 is very simple to install and can either be secure directly to suitable surface using the mounting holes on the module, or using the included wall bracket 3.1 Wiring Remove the iCAM100 lid by undoing the four screws (being careful not to loose the washers). -
Page 8: Mounting
Pass a screw through each hole in the bracket and into the raw plug. Tighten all screws firmly. Attach the mounting plate to the iCAM100 module using the bolts and washers supplied Then attach the plate to the Wall bracket, and tighten all nuts firmly... -
Page 9: Pan And Tilt Adjustment
3.2.3 Mounting the Camera Directly The iCAM100 enclosure has four mounting holes located on its underside, which can be used to mount the camera directly or to the mounting plate for use with the wall bracket. -
Page 10: Operation
Installation and Operating Manual 4 Operation Once the iCAM100 is wired up, the unit simply requires is power and a suitable monitor to view the picture. There are no other adjustments on the camera itself apart from pointing the camera in the required direction using the pan and tilt. -
Page 11: Ec Declaration Of Conformity
Installation and Operating Manual 5 EC Declaration of Conformity... - Page 12 Installation and Operating Manual...
-
Page 13: Manual Revision History
Installation and Operating Manual 6 Manual Revision History Revision Description Date Initial Release, replaces 302803_16 16/05/2014...
Need help?
Do you have a question about the iCAM100 and is the answer not in the manual?
Questions and answers