Page 1
KLANG WERK BLACET RESEARCH MODEL 2010 BALANCED MODULATOR Users Manual Blacet Research 15210 Orchard Rd Guerneville CA 95446 blacet@blacet.com http://www.blacet.com 707-869-9164 Contents Copyright. Reproduction by any means including the Internet prohibited without permission. This document contains proprietary and trade secret information of Blacet Research and is provided as a service to the module owner.
Introduction Klang Werk is a high quality balanced (or “ring”) modulator with a number of built in features making it more versatile than the usual synth module. It’s more like an effect box, although it is right at home in any modular system.
Source switch. The external signal should be in the 0-10V range. For audio signals, the AC/DC switch should be in AC. To use the Klang Werk as a VCA with the carrier input being a control voltage, place the switch in the DC position.
Page 4
TYPE *shield not connected this end 3.5” shielded* strip 0.5” Switch Pins 3.3” 2.3” 2.5” 8.0” 4.5” 3.8” 8.5” strip 1.6 3.4 strip 1.8” 2.9” 2.9” 5” 5” 5” 6.7” Calibration The four on-board trim pots need to be adjusted for optimum performance. All these adjustments should be done with the MIX control FCW.
signal is not present. The optimum setting for the trimmer is affected a bit by the SIGNAL GAIN and MIX controls, so you should find their most typical settings , based upon your system levels, before you set the trimmer. To set RT4, turn the FREQ control FCW and turn up your amp.