Fog Lamps; Side Identification Marker; Lamps - Cadillac CTS 2013 Owner's Manual

Fog Lamps

To replace a front fog lamp bulb:
1. Pull out the push-pins on the
underside of the protection
shield to remove the shield.
2. Reach up behind the front
bumper area from under the
vehicle to access the lamp
housing.
3. Remove the electrical connector
from the bulb by lifting the two
plastic clips.
4. Remove the bulb socket from
the lamp housing by turning the
bulb socket one-quarter turn
anticlockwise.
5. Pull the old bulb from the lamp
housing keeping the bulb
straight as you pull it out.
6. Install a new bulb.
7. Reinstall the electrical connector
by pushing in the two plastic
clips.
8. Push the bulb socket into the
lamp housing and turn the
socket one-quarter turn
clockwise.

Side Identification Marker

Lamps

To replace one of the side
identification marker lamp bulbs:
1. Gently slide the front part of the
lamp assembly along the wing
toward the rear of the vehicle.
2. When the tab at the front end of
the assembly disengages from
the wing, pull the front end of the
lamp assembly away from
the wing.
Vehicle Care
3. Remove the lamp assembly from
the wing.
4. Turn the bulb socket
anticlockwise to remove it and
replace the bulb.
5. Insert the socket into the lamp
assembly and turn it clockwise
to secure it.
6. Reinstall the lamp assembly.
When reinstalling the lamp
assembly, align the tab on the
front of the lamp assembly with
the front edge of the wing hole,
then snap the rear part of the
assembly into the hole in
the wing.
10-33