Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Powerware Expansion Chassis
- Page 1 ® Powerware Expansion Chassis User’s Guide www.powerware.com...
- Page 2 Powerware is a registered trademark and X-Slot is a trademark of Powerware Corporation. Modbus is a registered trademark of Modicon. Copyright 2002 Powerware Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Powerware Corporation.
-
Page 3: Installation
C H A P T E R 1 NSTALLATION The Powerware Expansion Chassis is a connectivity device that contains a Modbus Card and two slots for other X-SlotZ connectivity devices, providing greater power management control and flexible monitoring. Refer to the respective user’s guide for operation of the X-Slot cards to be used in the chassis. - Page 4 UPS. For the Powerware 9315 UPS. The Powerware 9315 UPS is not compatible with the Relay Interface Adapter or the Single Port Serial Card. Both cards require open collector signals (AC Fail and Low Battery), and the 9315 only provides RS-232 serial data through the communication port.
- Page 5 Installation Installing the Expansion Chassis The Expansion Chassis can be installed three different ways: as a freestanding device : wall-mounted rack-mounted, using only 1U of valuable rack space To install the chassis, perform the following steps: Attach the supplied adhesive feet Freestanding Installations Only.
- Page 6 (see Figure 3). Mount the chassis in the rack. Continue to Step 4. Figure 3. Attaching the L-Bracket 4. Connect the supplied serial cable (Powerware part number 124102022) to the communication port on the chassis rear panel (see Figure 4).
- Page 7 UPS or an outlet powered by the UPS. This allows the chassis to be protected during a power outage. NOTE For UPSs with load segments, it is recommended to plug the Expansion Chassis into the last group to be powered down. This allows the chassis to be powered as long as the UPS before it shuts down completely.
- Page 8 UPS Communication Port Power Indicator NORM AUX Auxiliary Switch Figure 6. Expansion Chassis Front Panel 12. Refer to the individual X-Slot card user’s guide to set up the card for communication with your serial devices or network. Powerware Expansion Chassis User’s Guide Rev A www.powerware.com...
-
Page 9: Troubleshooting
UPS is not responding. the chassis and to the UPS. Verify that the UPS is powered on. Service and Support If you have any questions or problems with the Expansion Chassis, call your or the at one of the following telephone... - Page 10 A replacement or repair unit will be shipped, freight prepaid for all warrantied units. NOTE For critical applications, immediate replacement may be available. Call the Help Desk for the dealer or distributor nearest you. Powerware Expansion Chassis User’s Guide Rev A www.powerware.com ®...
-
Page 11: Two-Year Limited Warranty (Us And Canada Only)
Powerware Corporation will repair or replace the warranted Unit at no cost to the customer for parts and labor. Equipment supplied by Powerware Corporation, but not manufactured by Powerware Corporation, is warranted solely by the manufacturer of such equipment. -
Page 12: International Limited Warranty
Force Majeure Powerware Corporation shall not be liable for any delays or defaults hereunder by reason of fire, floods, acts of God, labor troubles, accidents to machinery, delays of carriers or suppliers, inability of suppliers to supply, the impositions of priorities, restrictions or other acts of government, or other causes beyond its reasonable control. - Page 13 89/336/EEC, Council Directive relating to electromagnetic compatibility 92/31/EEC, Amending Directive 89/336/EEC relating to EMC The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC Declaration of Conformity, contact: Powerware Corporation Koskelontie 13 FIN-02920 Espoo Finland...
Need help?
Do you have a question about the Expansion Chassis and is the answer not in the manual?
Questions and answers