Timing Chain And Tensioner - Vision R82 Owner's Manual

Chapter 2 - Set-Up & Adjustment Chapter 2 - Set-Up & Adjustment
Chapter 2 - Set-Up & Adjustment Chapter 2 - Set-Up & Adjustment Chapter 2 - Set-Up & Adjustment
T T T T T iming chain and T iming chain and T iming chain and T iming chain and Tensioner iming chain and T ensioner ensioner ensioner ensioner
The front chain has a chain tensioner in the loop to keep the
timing chain tight. When the chain is not installed, the idler sits
on the bike as in fig 1. (below). Rotate the idler counterclock-
wise (fig 2), and end up with the idler as shown in fig. 3. Now
route the chain from the bottom of the chainring —heading to
the back of the bike—through the idler, following the arrows.
You should set the chain length so that, after the boom is ad-
justed for the captain, the idler is positioned like fig. 2.
Fig 1
16
Fig 3
Fig 2
Chapter 2 - Set-Up & Adjustment Chapter 2 - Set-Up & Adjustment
Chapter 2 - Set-Up & Adjustment Chapter 2 - Set-Up & Adjustment Chapter 2 - Set-Up & Adjustment
IPS Unit IPS Unit
IPS Unit IPS Unit IPS Unit
Your Vision tandem may be equipped with our Independent
Pedaling System. This system allow for the stoker and captain
to pedal at different intervals. This pedaling system can maxi-
mize the enjoyment of tandem riding, especially if two people
aren't at the same level of fitness. The IPS requires no extra
effort for maintaining it. Just treat it like any other normal
crankset.
17