Advertisement
Quick Links
harbor cub
assEMbly & opErating instructions
read this material before using this product.
Failure to do so can result in serious injury.
saVE this Manual.
Copyright
2005 by Harbor Freight Tools
©
tained herein may be reproduced in any shape or form without the express written consent of Harbor Freight
Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual
product may differ slightly from the product described herein. Tools required for assembly and service may not
be included.
For technical questions or replacement parts, please call 1-800-444-3353.
Revised Manual 09k
Electric remote
control airplane
Model
IMPORTANT:
If damage is caused due
to a crash, your warranty
Visit our website at: http://www.harborfreight.com
. All rights reserved. No portion of this manual or any artwork con-
®
92906
is void.
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for harbor cub 92906
- Page 1 Electric remote control airplane Model 92906 assEMbly & opErating instructions IMPORTANT: If damage is caused due to a crash, your warranty is void. Visit our website at: http://www.harborfreight.com read this material before using this product. Failure to do so can result in serious injury.
- Page 2 Keep your work area clean and well lit. Cluttered benches and dark areas invite acci- dents. Always check hardware and assembled parts after assembling. All connections should be tight and hardware tightened. Rev 09j For technical questions, please call 1-800-444-3353. SKU 92906 Page 2...
-
Page 3: Please Read The Following Carefully
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. REV 05j For technical questions, please call 1-800-444-3353. SKU 92906 Page 3... - Page 4 Speed Controller Ribbon Spinner Nut Crystals (pair) Assembly Diagram NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. REV 08j For technical questions, please call 1-800-444-3353. SKU 92906 Page 4...
- Page 5 Tail Screw (22) With Servos energized adjust the clips on the pushrods, until both the elevators and rudder are straight and level. REV 08j For technical questions, please call 1-800-444-3353. SKU 92906 Page 5...
- Page 6 Cover (19). Turn the tabs over the edge of the Cover to secure it. Switch “OFF” the “ON/ OFF” Switch on the Remote Control (11). Remove cover and insert eight “AA” batteries (not included) into the Remote Control (11). REV 06e For technical questions, please call 1-800-444-3353. SKU 92906 Page 6...
- Page 7 Choose a day when the wind is light. The Ribbon (27) attached to the Remote Control antenna should be blowing slightly (not greater than 30 degrees) and not be blowing straight out. Find a wide-open field. REV 08j For technical questions, please call 1-800-444-3353. SKU 92906 Page 7...
- Page 8 Continue to gradually decrease the Propeller (9) speed until you bring it to a stop and land the Airplane. If airplane descends too quickly, press slightly harder on the plane speed control to compensate. REV 08j For technical questions, please call 1-800-444-3353. SKU 92906 Page 8...
Need help?
Do you have a question about the 92906 and is the answer not in the manual?
Questions and answers