Do you have a question about the Spas and is the answer not in the manual?
Questions and answers
Gregory Kester
May 12, 2025
where can I get a motor for m Hot tub?
1 comments:
Mr. Anderson
May 21, 2025
The context does not provide specific information about where to find a motor for South Seas Spas hot tub. However, it does mention parts for Artesian and South Seas Spas, such as heaters and diverter kits, being sold on SpaPartsNet.com. You may be able to find a motor there.
Congratulations on the purchase of your new spa. We know YOU CAN EASILY FIND IT WHEN NEEDED. The serial and you will enjoy your spa. Although spas are relaxing and fun, we model numbers are mounted on the base of the equipment believe they can be an indispensable part of a healthy lifestyle.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS PLEASE TAKE THE TIME TO READ ALL OF THESE WARNINGS 8. DANGER - Risk of Electric Shock - Do not permit any electrical AND CAUTIONS PRIOR TO USING YOUR SPA. appliance such as a light, telephone, radio, or television, within 5 feet (1.5m) of a spa.
Page 5
The use of alcohol, drugs or medication before or during spa or hot tub use may lead to unconsciousness with the possibility of drowning. Spas equipped with the Audio system should follow these guide- lines for safety: e) Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory system problems, or diabetes should consult 1.
The most common style of GFCI also provides high-current protection ELECTRICAL REQUIREMENTS AND as a circuit breaker. (See Page 9 for GFCI Breaker. See Page 19 for INSTALLATION GFCI Test Feature.) The following information is provided for hooking up electrical supply to One of the two configurations of GFCI’s, as shown, will be required for your new spa.
VOLTAGE CHECKS 120VAC WIRING SCHEMATIC Set voltmeter to AC Volts. Voltages should check out as follows: Line 1 Black to Line 2 Red – 240VAC (Range of acceptability: 216VAC – 246VAC) Either Line to Neutral – 120VAC (Range of acceptability: 108VAC – 132VAC) Either Line to Ground –...
240VAC WIRING SCHEMATIC 50 Hz ELECTRICAL SERVICE OPTIONS Single Service, TN and TT Electrical Systems (1 X 16 Amp or 1 X 32 Amp) 3 Wires (1 Line + 1 Neutral + 1 Protective Earth) Protective Earth wire (Green / Yellow) must be connected to system ground terminal as marked.
Page 10
50 Hz ELECTRICAL SERVICE OPTIONS 50 Hz ELECTRICAL SERVICE OPTIONS Single Service, IT Electrical System (No Neutral) Line - Line voltage is 230VAC (1 X 16 Amp or 1 X 32 Amp) 3 Wires (2 Lines + 1 Protective Earth) Protective Earth wire (Green / Yellow) must be connected to system ground terminal as marked.
5) INDOOR SPAS: Floor surface must have traction to prevent slipping when wet. A floor drain is optimum. As room humidity will increase be- cause of the spa, provide ample ventilation to prevent dry rot, mildew and mold.
SPA START-UP VS/GS SERIES CONTROL OPERATIONS FILLING THE SPA WITH WATER When your spa is first actuated, it will go into Priming mode which is indicated by “Pr”. This Priming mode will last for 5 minutes and then the spa will begin to heat the spa and maintain the water tempera- 4) Fill the spa to the bottom of the pillows or about 6-8 inches from the ture in the Standard Mode.
PRESET FILTER CYCLES MODE The mode is changed by pressing the “Warm” The filter cycle begins 6 minutes after the spa is energized. The second filter cycle begins 12 hours later. Filter duration is programmable or “Cool” button, 2, 4, 6, or 8 hours for continuous filtration (Indicated by “FC”). The default filter time is 2 hours.
DIAGNOSTIC MESSAGES MAINTAINING YOUR SPA PILLOW CARE “Ice” - Potential freeze condition No action required. The pump and blower will automatically Clean the pillows with soapy water and a soft cloth when needed. Use activate regardless of spa status. a vinyl conditioner once a month. Remove pillows when doing chemical shock treatment.
MAINTAINING YOUR SPA REMOVING, INSTALLING AND CLEANING FILTERS These are the steps needed to successfully replace your filters. You WINTERIZING YOUR SPA should clean your filters every four months. It is not recommended that you drain your spa completely during freez- 1) Turn off all power to your spa and remove the filter lid by lifting it out ing conditions.
However, it is important that you do not use any abrasive cleaners or strong chemicals. Your South Seas Spas authorized dealer will be able to supply you with the proper cleaning solution for your spa. After cleaning, make sure all resi- dues are removed prior to filling the spa.
WATER CHEMISTRY CHEMICAL TREATMENT OF WATER Water from your tap is fine for showers, bathing and drinking. However, CAUTION: The chemicals used to maintain the pH balance of the water in a contained recirculating system such as in a spa, water must be and to sanitize the water can be dangerous.
Page 18
4 - Sanitizers: Sanitizers are used to destroy bacteria and other germs chemical prevents the ions from reacting with one another, thus forming in the water. Only 2 sanitizers are used in spas, chlorine (Sodium Di- complex structures or solids.
Page 19
26 - Brominator: Feeding devices used to introduce bromine into pools els of chloramines can cause the problems of “Red Eyes” or “Stinging or spas. Most automatic types can be plumbed inline. Others are simple Eyes.” Usually requires a shock treatment to lower or destroy the com- floating varieties.
Page 20
PPM level. even your heater. 3 - Foam Gone: Foam in spas is typically caused by residue from soap, 9 - Spa Shock: Non-chlorine spa shock contains Potassium Monop- shampoo, and cleansers. A small amount of Foam Gone will dissipate ersulfate and is an oxidizer that works well with mineral, chlorine and the foam and will not affect the water balance.
Page 21
LIFETIME STRUCTURE WARRANTY is acidic. You should maintain a slightly alkaline pH level, between 7.2 South Seas Class Spas carry a liftetime structure warranty. The struc- and 7.8, in the hydrotherapy spa. Severe problems can occur when the ture is defined as the fiberglass vessel below the exposed material fin- pH balance is not maintained within this range.
Page 22
PRODUCT WARRANTY THIS WARRANTY IS GIVEN ONLY TO THE ORIGINAL OWNER, AND TERMINATES UPON TRANSFER OF OWNERSHIP. COM- MERCIAL APPLICATIONS ARE EXCLUDED FROM THIS AND ALL The manufacturer will not pay for removal, installation, cranes, construc- WARRANTIES. The spa must be set on a level solid surface that is tion, de-construction, or any other cost associated with access, egress, or sufficient to support the entire length and width of the spa.
Page 23
Chemical Misuse / Damage homeowner and will not under any circumstances be covered by May Filter Lids Manufacturing LLC. Any Part not Purchased from South Seas Spas Jet Inserts LIMITATIONS Valve Handles Pump Seals...
Page 24
Any alteration of the spa that has not been pre-authorized by the INTERIOR SPA DIAGRAM manufacturer will void all warranties. If the maunfacturer approves an alteration, verify that this alteration is covered under warranty. Dam- age caused by moving a spa that is blocked in or that has been re- cessed, along with additional charges for labor, is not covered by this 1) Spa Pack 2) Heater...
Need help?
Do you have a question about the Spas and is the answer not in the manual?
Questions and answers
where can I get a motor for m Hot tub?
The context does not provide specific information about where to find a motor for South Seas Spas hot tub. However, it does mention parts for Artesian and South Seas Spas, such as heaters and diverter kits, being sold on SpaPartsNet.com. You may be able to find a motor there.
This answer is automatically generated
how do I set the time on my spa?