Table of Contents
Advertisement
Command
#dynamic_edid
#edidbatolo
#ediddetolo
#ediddstoba
#ediddstolo
#lock_edid
#prbaedid
#prdsedid
#predidst
#prloedid
#dynamic_edid Command
The #dynamic_edid command provides the ability to route any downstream
EDID to any input. When enabled, the EDID is copied to all inputs from the last
selected active output. When disabled, the EDID is copied to all inputs from the
first active display detected, starting from Output 1.
Syntax:
#dynamic_edid param1
Parameters:
param1
Notes:
The default setting for Dynamic EDID is disabled.
Example:
#dynamic_edid 1
Enable Dynamic EDID mode
RS-232 / TELNET COMMANDS
EDID Management
Description
Enables / disables dynamic EDID
Read downstream EDID and stores in any Local Input
Sets Local EDID to Default EDID
Read downstream EDID and stores in EDID Bank
Read downstream EDID and stores into a Local EDID
Secures Local EDID
Read EDID from an EDID bank and sends to serial port
Read downstream EDID and sends to serial port
Prints EDID details
Read Input Local EDID and sends to serial port
Value
Value
0
1
Meaning
Disable
Enable
30
[0 - 1]
Advertisement
Table of Contents
