Download Print this page

DLS PD408-AN10-277 User Manual

0-10v analog control 4 channel x 2250 w dimmer & switch packs 220/240/277 volts operation

Advertisement

Quick Links

Digital Lighting Systems, Inc.
PD408-AN10-277
ANALOG 0-10 V
0-10V analog control
4 Channel x 2250 W Dimmer & Switch Packs
220/240/277 Volts operation
PD408-AN10-277
4 circuit Analog 1-10V
4 x 8 A. Dimmer pack
Digital Lighting Systems,Inc
www.digitallighting.com
1-305-969-8442
Info@digitallighting.com
USER'S MANUAL
Serial Number
1
2
3
4
Made in USA
Dimmers Indicators
PD408-AN10-277-UM
- 10/12

Advertisement

loading

Summary of Contents for DLS PD408-AN10-277

  • Page 1 Digital Lighting Systems, Inc. PD408-AN10-277 ANALOG 0-10 V 0-10V analog control 4 Channel x 2250 W Dimmer & Switch Packs 220/240/277 Volts operation Serial Number PD408-AN10-277 4 circuit Analog 1-10V 4 x 8 A. Dimmer pack Digital Lighting Systems,Inc www.digitallighting.com 1-305-969-8442 Info@digitallighting.com...
  • Page 2: Specifications

    Dimmer power specifications: Operating Voltage: 277 VAC Each channel of the PD408-AN10-277 could be set to dim or switch. 4 Jumpers, 1 for each channel, are located on the back of the front cover. Input : 2 x 20 Amp Breaker on 1 phase Place jumper on D side for normal 0-10V dimmer operation, place jumper on S side for switch operation.
  • Page 3: Enclosure Installation

    Refer to the drawings below (FIGURE 3) for the correct dimensions. Conduit shall be pulled to the top of the dimmer packs. NOTE The PD408-AN10-277 may create a slight buzzing noise and should not be located where this is objectionable. Figure 3 - PD408-AN10-277 Dimensional Diagram Top View 8.30"...
  • Page 4 All wiring between the control stations, dimmers, and other system Analog 0-10V Control inputs controllers (network bus) is low voltage (NEMA Class 2) PD408-AN10-277 dimmer packs may be fed by one or two 20 A (maximum) branch circuits and may have up to four separately dimmed Control Control loads.
  • Page 5: Limited Warranty

    LIMITED WARRANTY Digital Lighting Systems, warrants to the purchaser that its Upon request, replacement unit(s) will be shipped as soon as products have been carefully manufactured and inspected and available. Unless immediate shipment of replacement are warranted to be free from defects of workmanship and merchandise is requested, Digital Lighting Systems will not materials when used as intended.