Linn AKURATE Owner's Manual page 17

AKURATE 226
English
Description and available settings for parameters
Default settings are shown in grey.
Parameter Symbol
External high pass
frequency.*
Increasing the setting
reduces the bass content
sent to the external
loudspeakers. (Hz)
Internal high pass
frequency.
Increasing the setting raises
the lowest frequency
produced by the unit. (Hz)
Internal low pass
frequency.**
Increasing the setting raises
the highest frequency
produced by the unit.
Reducing the setting lowers
the highest frequency
produced by the unit. (Hz)
Coarse gain. Every one step
increase in the setting raises
the gain (volume) of the
loudspeaker by 5 decibels.
Every one step decrease in
the setting lowers the gain
(volume) of the loudspeaker
by 5 decibels. (dB)
Fine gain. Every one step
increase in the setting raises
the gain (volume) of the
loudspeaker by 1 decibel.
(dB)
AKURATE Loudspeaker System
Owner's Manual
0 1 2 3 4 5 6 7 8 9
1 0 5 0 7 5 1 0 0 1 1 5 1 3 5 1 6 0 1 9 0 2 3 5
1 8 2 2 2 5 3 0 3 4 4 0
5 5 8 5 1 3 0
1 - 5 1 - 0 5 - 0 + 5 + 1 0 + 1 5
0 + 1 + 2 + 3 + 4
Parameter Symbol
Bass equalisation.
Every one step increase in
the setting applies an
additional 3dBs at 30 Hz and
below. (dB@30 Hz)
Time out. Length of time
before unit will go into
standby after audio input
ceases. (mins)
Phase. Depending on the
position of the Akurate 226
loudspeaker relative to
others in the system, better
performance may be
achieved by changing this
setting.
* Only for use when the AKURATE 226 speaker is connected to a power
amplifier (see Connecting section in this chapter).
** If you are using the AKURATE 226 speaker with a Linn System
Controller or other AV processor, set to 4 (No filtering).
12
0 1 2 3 4 5 6 7 8 9
0 + 3 + 6
5 1 0 2 0