Remote Controller; Outdoor Unit; Setting Current Time; Preparation Before Operation - Mitsubishi Electric MFZ-KJ25VE Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Air outlet
Multi-fl ow vane
Air cleaning fi lter (Anti-Al-
lergy Enzyme Filter)
Front panel
Air fi lter
(Nano platinum fi lter)
Display and operation section
(When the front panel is opened)
Remote control receiving section
Operation indicator lamp

Outdoor unit

Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Horizontal vane
Vertical vane
Fan guard
Panel
E.O
Emergency operation
SW
switch
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
2.
Insert the negative
pole of AAA
alkaline batteries fi rst.
3.
Install the front lid.

Remote controller

Operation
display section
Temperature
buttons
Page 4
Operation
select button
Page 4
ECONO COOL
button
Page 6
i-save button
Page 6
CLOCK button
Page 3
Remote controller holder
• Install the remote con-
troller holder in a place
where the signal can be
received by the indoor
unit.
• When the remote con-
troller is not used, place
it in this holder.

Setting current time

1.
Press CLOCK.
4.
Press CLOCK again.
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
ON/OFF
(operate/stop) button
FAN speed control
button
Page 5
VANE control
button
Page 5
TIME, TIMER set buttons
Pages 3, 6
Increase time
Decrease time
WEEKLY TIMER
set buttons
Page 7
RESET button
Page 3
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
Only use the remote controller provid-
ed with the unit.
Do not use other remote controllers.
If two or more indoor units are installed
in proximity to one another, an indoor
unit that is not intended to be operated
may respond to the remote controller.
3.
Press the DAY button
to set the day.
2.
Press either the TIME button
or the TIMER buttons to set
the time.
Each press increases/decreas-
es the time by 1 minute (10
minutes when pressed longer).