Advertisement
After determining the height of stand, follow the installation instructions in below
to install wall mount to different kinds of wall -wooden, brick, concrete and stone.
Wooden wall:
Wooden wall:
Us i n g a a w l o r n a i l t o m a ke where the nails are located, as shown as fig.2b. Pre-drill
these holes with a 5mm drill bit to at least 40mm in deep hole. Please make sure
these holes are level and located at center. Use wall mount as a template to mark the
location of other
three
holes and drill the same holes. Fix the wall mount to the wall
with long bolts(J) and washers(L).
4
Brick, Concrete and Stone wall:
Brick, Concrete and Stone wall:
Using the wall mount as template to mark 4 holes location on the wall. Two holes are
located at the top row of the slots and two more are located at the bottom row. Please
make sure these holes are level. Pre-drill these holes with a 10mm drill bit to at least
50mm deep hole. Insert wall anchors(K) into each of these holes. Attach the wall
mount to the wall using 4 long bolts(J) and washers(L). as shown as fig.2c.
Fig 2b
1
L
J
Fig 2c
WARNING
We are not responsible for any personal injury or product damage due to mishandling,
incorrect mounting, incorrect assembly or incorrect use of this product.
Note:
The supplied wall mounting hardware is not for use on steel stud walls or cold
cinder block walls. If you are uncertain about the nature of your wall, please consult a
qualified contractor. If the hardware you required is not included please contact your
local hardware store.
Caution :
Caution :
This Product LCD /Plasma Wall Mount Bracket is intended for use only
with the maximum weights indicated .See apparatus instructions .Use with products
heavier than the maximum weights indicated may result in instability causing possible
injury .
Step 1: Attach bracket to TV
Step 1: Attach bracket to TV
Check your TV manual to confirm the diameter of bolt to be used or choose an
appropriate bolt according to size, height and position of the holes on your TV. See
pages 4 of these instructions for examples.
For correct installing, make sure that hook of every bracket must facing down. Use
selected bolts and washers for installing bracket at the back of display. Adjust two
brackets to equal heights and level. Once aligned, tightly secure the bolts.
"
"
.
the
UP side on the top
As shown in Fig.1a.
IMPORTANT
IMPORTANT:
Don't force the bolt into the hole, which will cause a damage of
equipments and injure of person. Don't use electric drill to fasten any bolts.
Note:
Note:
Fig.1a
Advertisement
