Tools Needed; Accessing The Sca Drive Tray And Installing A Hdd - Advantech DNS-3000 User Manual

2.2.2 Tools Needed

1. Phillips screw driver
2. Antistatic strap (recommended)

2.2.3 Accessing the SCA Drive Tray and Installing a HDD

To install the SCA drive into the chassis, you need to first remove the
SCA drive tray from the chassis.
Procedures
1. Press the release tab located on the drive tray door to release the
drive tray from its locked position as shown below.
2. Pull the drive tray door upward and then pull the SCA drive tray
out from the chassis.
3. Mount a hard drive in the drive tray and make sure that all the
screws are securely fastened.
DNS-3000 User's Manual 12