Autopage C3-RS-730 LCD Operation Manual page 12

Professional 2-way lcd remote car starter & alarm system with built in temperature, voltage sensor and two-way serial port data link
Table of Contents

Advertisement

SVMASTER -
2. Immediatel y depress the
buttons, if you program
siren or horn chirps (4) times. The vehicle is no longer programmed to start automatically.
F. TEMPERATURE CHECK
With the built in temperature sensor you can monitor, Through the LCD screen, the present indoor
temperature of the passenger compartment of your vehicle.
Press and hold the transmitter "
more times so that TEMP appears on the remote. Within 3 seconds press
temperature will be shown on the LCD screen. This reading may be higher than actual ambient temperature
due to the greenhouse effect and is relative only to the inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button once on the remote transmitter under the remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate the engine has stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut
down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The parking (hand) brake is released (For Turbo Timer Mode)
4. Engine is over-revved. {"Tachometer checking type" only}
5. The pre-programmed run time
6. Press
button on the remote transmitter under remote start mode.
7. The system trigger.
8. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system's remote start unit to be temporarily disabled to prevent the vehicle from
being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the OFF
position.
ADVANCED USER'S MODE:
C. LCD REMOTE CONTROL TRANSCEIVER OPERATION:
Enter: Press and hold
as below.
Exit: Press the
SVMASTER -
button then press and hold the
+
buttons = Start / Stop button.) The parking light will flash (4) times. The
F
"
button first until 3 chirps are heard. Then press the
(5 /10 / 20 / 30 minutes)
F
Button until beep sound respond from LCD transceiver indicate into table 1 – 5
,
or
button to exit this mode.
http://www.msvmaster.lv
-
button for 2 seconds. (or depresses
has elapsed.
http://www.msvmaster.lv
-
12
+
F
Button three
button; the in-door

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents