Warranty Terms And Conditions; Limited Warranty; Specifications - Audio Research LP1 Owner's Manual

Limited Warranty

Audio Research Corporation products
are covered by a
Warranty, or a 90-Day Limited Warranty
(vacuum tubes). This Limited Warranty
initiates from the date of purchase, and
is limited to the original purchaser, or in
the case of demonstration equipment,
limited to the balance of warranty
remaining after original shipment to the
retailer or importer. In the United States,
the specific terms,
remedies for fulfillment of this Limited
Warranty are listed on the warranty card
accompanying the
shipping carton, or may be obtained
from the authorized retailer or from the
Audio Research Customer
Department. Outside the United States,
the authorized importing
distributor has accepted
responsibility for warranty
Research products sold by them. The
specific terms and
fulfillment of the Limited Warranty may
vary from country to country. Warranty
service should normally be obtained
from the importing retailer or distributor
from whom the product was purchased.
In the unlikely event that technical
service beyond the
importer is required, Audio Research will
fulfill the terms and conditions of the
Limited Warranty. Such product must be
returned at the purchaser's expense to
the Audio Research factory, along with
a photocopy of the dated purchase
receipt for the product,
description of the
encountered, and any
necessary for return shipment. The cost
of return shipment is the responsibility of
the purchaser.
3-Year Limited
conditions and
product in its
Service
retailer or
the
of Audio
remedies for
ability of the
a written
problem(s)
information
3900 Annapolis Lane North
Plymouth, MN 55447
763.577.9700
www.audioresearch.com

Specifications

FREQUENCY RESPONSE: ± 0.3dB of RIAA, 10Hz
to 20kHz.
DISTORTION: Less than .019% at .5V RMS SE
output.
GAIN: 47dB at 1kHz.
SWITCHES: Power, Mute.
INPUT IMPEDANCE: 47k ohms (0.7 to 7mV high
output cartridge recommended).
OUTPUT IMPEDANCE: 5.5k ohms Single Ended
(Single Ended RCA connectors). 60k ohms
minimum load and
capacitance.
OUTPUT POLARITY: Non-Inverting.
MAXIMUM INPUTS: 40mV RMS 1kHz, 100mV
RMS 10kHz.
RATED OUTPUTS: .0.5V RMS Single ended into
100k load (maximum output 15V RMS at 1%
THD at 1kHz).
POWER SUPPLIES: Electronically-regulated low
and high voltage supplies. Automatic 40
sec. warm-up/brown-out
regulation better than .01%.
NOISE: 0.4µV RMS IHF weighted equivalent
input noise, shorted input 74dB velow 2mV
RMS 1kHz input).
TUBE COMPLEMENT: (1) 6H30 dual triode.
POWER REQUIREMENTS: 100-135 VAC 60Hz
(200 - 270VAC 50/60Hz) 35 watts maximum.
DIMENSIONS: 11.3" (33 cm) W x 4.5" (11.4 cm)
H x 8.6" (21.8 cm) D. Rear chassis fittings
extend 0.6" (1.5 cm).
WEIGHT: 9 lbs
Specifications subject to change without notice.
©2012 Audio Research Corporation.
100pf maximum
mute. Line
7