Nexx SX.COM User Manual

Bluetooth headset & intercom for scooters and motorcycles
Hide thumbs Also See for SX.COM:

Advertisement

Bluetooth ® Headset & Intercom
for Scooters and Motorcycles
User's Guide
www.nexx-helmets.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SX.COM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Nexx SX.COM

  • Page 1 Bluetooth ® Headset & Intercom for Scooters and Motorcycles User's Guide www.nexx-helmets.com...
  • Page 2: Table Of Contents

    Two-year Limited Warranty ................. 25 6. INTERCOM CONVERSATION ..............16 Limitation of Liability ................... 25 Pairing with Other SX.COM Headsets for Intercom Conversation ..... 16 Return for Full Refund ................26 Starting and Ending Intercom Conversation ..........16 WARNING ......................26 Intercom and Mobile Phone Call ..............
  • Page 3: Introduction

    • Bluetooth stereo headset for Bluetooth stereo devices such as MP3 players Thank you for choosing the NEXX SX.COM, Bluetooth Headset and Intercom for Scooters and Motorcycles. With the SX.COM, you can • Bluetooth stereo headset for Bluetooth GPS navigations • Bluetooth intercom up to 200 meters (220 yards)*...
  • Page 4: Package Contents

    PACKAGE CONTENTS 2. PACKAGE CONTENTS Status LED Pin-hole DC Power Charging & (-) Button Reset Button Firmware Upgrade Port (Intercom Button) USB Power & Data Cable Speakers (+) Button (Phone Button) Microphone Velcro Pads Microphone Sponges for Speakers SX.COM Headset...
  • Page 5: Getting Started

    SX.COM GETTING STARTED 3. GETTING STARTED Installing the SX.COM on Your Helmet 1. Place the speaker-microphone unit in the helmet along with the velcro pads, centered to your ear, in the ear pockets of the helmet. Locate the boom microphone as closely as possible to your mouth when wearing the helmet.
  • Page 6: Powering On

    “Goodbye” and descending beeps. Charging the SX.COM You can charge the SX.COM by connecting the supplied USB power & data cable into a computer USB port or USB wall charger. You can use any standard micro-USB cable to charge the SX.COM. The LED turns red while charging, and turns blue when the headset is fully charged.
  • Page 7: Checking Battery Level

    SX.COM Checking Battery Level You can check the battery level in two different ways when the headset is powering on. LED Indicator When the headset is powering on, the red LED flashes rapidly indicating the battery level. Status Note: 4 flashes High, 70~100% 1.
  • Page 8: Adjusting The Volume Level

    Bluetooth MP3 music. So you can always maintain the preferred When the SX.COM is not working properly or is in faulty status for any optimum volume level for each audio source.
  • Page 9: Operation Quick Reference

    Operations Function 4. OPERATION QUICK REFERENCE 5 sec. Sena SMH3 v1.0 Operations Function 1 sec. 1 sec. Power Bluetooth Select NEXX SX.COM On/Off Sena SMH3 Pairing (Phone, MP3, 1 press 1 press GPS) Volume Sx.Com v1.0 Sena SMH3 v1.0 Adjustment...
  • Page 10 SX.COM Operations Operations Function Function 1 press 1 sec. Answer 2 sec. 2 sec. Music 2 sec. 3 sec. Mobile Phone Voice Command 3 sec. 2 sec. Reject...
  • Page 11: Pairing And Using The Sx.com With Bluetooth Devices

    Mobile Phone Pairing simple procedures in “Mobile Phone Pairing”. 1 Turn on the SX.COM and press and hold the (+) Button for 5 seconds 2. To pair the second mobile phone, press and hold the (-) Button for 5 until the LED flashes red and blue alternately and you hear multiple seconds until the red LED is rapidly flashing and you hear multiple beeps.
  • Page 12: Bluetooth Stereo Device Pairing

    1. If the Bluetooth stereo device is integrated with the mobile phone such as smartphones, you don’t need to pair the SX.COM with it separately. When the SX.COM is paired with the mobile phone, it is also paired as a stereo music device.
  • Page 13 Pairing Pairing 3. Search for Bluetooth devices on the GPS navigation screen. Select the NEXX SX.COM in the list of the devices detected on the GPS. A2DP 4. Enter 0000 for the PIN. 5. The GPS confirms that pairing has completed and the SX.COM is ready to use.
  • Page 14 Bluetooth stereo music source, you can pair the GPS to the SX.COM by following the simple procedures in “Mobile Phone Pairing”. When you do this, the SX.COM thinks the GPS is a mobile phone. But the SX.COM can directly pair an additional mobile phone.
  • Page 15: Mobile Phone Call Making And Answering

    You can listen to stereo music by Bluetooth wireless stereo. The Bluetooth 4. To reject a call, press and hold the (-) Button for 2 seconds until you audio device must be paired with the SX.COM by following the “Bluetooth hear a beep while the phone is ringing.
  • Page 16: Intercom Conversation

    1. When you have an incoming mobile phone call during an intercom 1. Turn on the two SX.COM headsets (A and B) that you would like to conversation, you will hear a ring tone. You can choose whether to 1) pair with each other.
  • Page 17: Intercom Failure

    4 high tone beeps alerting them that there is an incoming intercom call. pressing the (-) Button. 4. If any button is not pressed within 10 seconds, the SX.COM will exit Intercom Reconnection the configuration and goes back to standby.
  • Page 18: Enabling/Disabling Voice Activated Phone Answering

    VOX feature does not work if you are connected to intercom. To delete all Bluetooth pairing information of the SX.COM, press and hold This is enabled from the factory but you can disable this. If this mode is the (+) Button until you hear a voice prompt, “Delete all pairings”, and...
  • Page 19: Reset To Factory Default Setting

    “Delete all pairings” Execute Execute “Factory reset” To restore factory default settings on the SX.COM, press and hold the (+) Button until you hear a voice prompt, “Factory reset”. Press the (-) “Exit configuration” Execute Button to confirm. The SX.COM powers off with a voice prompt, “Headset Voice Configuration Menu &...
  • Page 20: Firmware Upgrade

    8. FIRMWARE UPGRADE The product has an internal, non-removable, rechargeable battery. Do The SX.COM supports firmware upgrade function. Please visit not attempt to remove the battery from the device as you may damage Nexxpro,s.a. web site at www.nexx-helmets.com to check the latest the device.
  • Page 21: Maintenance And Care

    SX.COM MAINTENANCE AND CARE DISPOSAL The product should be treated with care and the following suggestions The crossed-out wheel bin symbol on the product, will help you protect your warranty coverage. literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be 1.
  • Page 22: Certification And Safety Approvals

    SX.COM CERTIFICATION AND SAFETY APPROVALS • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC Compliance Statement FCC RF Exposure Statement This device complies with part 15 of the FCC Rules.
  • Page 23: Industry Canada Statement

    ® The SX.COM is compliant with and adopts the Bluetooth Specification (the “Device”), and stop your Vehicle on the roadside prior to initiating 3.0 and has successfully passed all interoperability tests that are...
  • Page 24 4. You fully acknowledge our warnings and understand that: (a) risks and dangers exist in using the Device while in traffic, including but NEXX and Sena hereby notifies you that using this Device may also be in not limited to injury or illness, strains, fractures, partial and/or total contravention to local, federal, state or national laws or regulations, and paralysis, death or other ailments that could cause serious disability;...
  • Page 25: Two-Year Limited Warranty

    Product or assume the risk of loss or damage in transit, to prepay by not returning the Device for a full refund (see refund option below). shipping charges to NEXX , and to use the original shipping container or equivalent.
  • Page 26: Return For Full Refund

    PRODUCT. Return for Full Refund NEXX informs that using this device in public traffic may not be IF YOU ARE UNWILLING TO ACCEPT AND AGREE TO THE ABOVE authorized by the law. Please check your local law and use this device CONDITIONS, YOU MAY RETURN THIS DEVICE TO NEXX FOR A FULL only out of public traffic such as private properties or closed circuits.
  • Page 27 1.0.0 www.nexx-helmets.com User's Guide for Firmware v1.0...

Table of Contents