How To Operate Your Ceiling Fan - Landan FPD8087 Series Owner's Manual

1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 24).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
NOTE: Receiver in controllers system features an
automatic learning function. There are no frequency
switches on the receiver unit. The receiver will
automatically scan the frequency from the hand held
control if an changes are made. the frequency settings
should be changed only in the case of interference or
if multiple ceiling fans with the same type of control
system are installed in the same structure.
2. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off, arrange code switches to desired code setting.
Then follow the remote code setting process. (If not used
for long periods of time, remove battery to prevent damage
to transmitter). Store the remote away from excessive heat
or humidly (Figure 25).
3. Remote Control Setting and Speed (RPM)
Setting Process :
Step 1: Set code switches to desired code.
Turn power on to the fan. Within 60 seconds of
powering the fan on, press and hold the set
button inside the battery compartment of the
remote for 5 seconds. This will synchronize the
control with the fan motor receiver.
Step 2: Speed Setting: After step 1 is complete,
press/release the high speed (VI) button and allo
fan to run for 120 seconds. This will configure th
speeds within the motor electronics.
Step 3: Performing Speed Settings for the reverse
speeds: Press/release the reverse button on the
remote control. Once fan has reversed,
press/release the high speed (VI) button and allo
the fan to run for 120 seconds. (Figure 26).
Now the fan is ready for normal use.
4. The remote buttons instruct as below:
Fan speed:
I = minimum speed
III = medium low speed
V = medium high speed
Button:
This button turns the fan off.
Reverse button (back of remote):
This button is to control fan direction.
Up Light button /
The button is to control light, Infinite light levels
are available by holding the light on/off button
(Figure 27).

How to Operate Your Ceiling Fan

WARNING
II = low speed
IV = medium speed
VI = high speed
Down Light button:
NOTE: If you want to change the blades: turn
the off→ change the blades →turn the power
on →replay the power setting process.
12
MAIN FUSE BOX
Figure 24
Figure 25
Step 2
Step 3
Step 1
Figure 26
Figure 27