I. REMOVING THE TURNTABLE MOTOR
(1) Remove the turntable.
(2) Remove the rotating ring on the bottom plate of
oven cavity.
(3) Remove the base plate by removing 5 screws
securing it to the oven cavity. (Figure 17)
(4) Disconnect the leadwire from the turntable motor
terminals.
(5) Remove the 2 screws securing the turntable motor
to the oven cavity ASS'Y. (Figure 18)
NOTES:
• Remove the leadwire from the turntable motor
VERY CAREFULLY.
• Be sure to grasp the connector not the wires
removing.
Figure 17
Figure 18
when
Wire Leads
Turntable Motor
7-10