Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for NCS Products The Krasnogorsk-3
-
Page 1: Operating Instructions
The Krasnogorsk-3 Operating Instructions Sold by NCS Products, New York... - Page 2 Krasnogorsk-3 Owner’s Manual [6] Viewfinder [7] Light Meter FPS Dial [8] Light Meter Power Switch [9] Light Meter ASA/ISO Knob [10] Pistol Grip [11] Lens Focus [12] F-Stop Adjustment [13] Trigger [14] Speed Control [15] Winding Handle [16] Film Cutter [17] Feed Spindle [18] Footage Counter Arm [19] Footage Counter...
- Page 3 On some K-3’s the plastic film guides have been removed. In this case, just make the loop manually. The top loop should have about 4 perforations visible. The bottom loop about 7. As long as the camera runs properly, exact loop size is not critical. © 2003 NCS Products rev 3.00 Page 3 of 6...
- Page 4 In the beginning, you’ll just move the dirt around. ANIMATION / TIME-LAPSE The Krasnogorsk-3 can shoot one frame at a time for animation or time-lapse. There is a small hole at the rear of the camera where a cable release screws in. Any standard cable release used for 35mm film cameras can be used.
- Page 5 Avoid subjecting the camera to rapid temperature changes. Be especially aware that bringing a cold camera into a warm, moist environment can cause damaging condensation to form inside the camera. • Replace the lens cap after use. Avoid cross-threading the lens cap! © 2003 NCS Products rev 3.00 Page 5 of 6...
- Page 6 M42x1, “Pentax screw mount” or Bayonette Lens Filter Size 77mm Minimum focus 2 meters/ 6.6 ft (1 meter using diopter) Viewing Rotating-mirror reflex Viewfinder diopter +5 to -4 Shutter angle 150 degrees © 2003 NCS Products rev 3.00 Page 6 of 6...
Need help?
Do you have a question about the The Krasnogorsk-3 and is the answer not in the manual?
Questions and answers