Central Pneumatic 92917 Set Up And Operating Instructions Manual page 14

5. If the tool requires more force to
accomplish the task, verify that the
tool receives sufficient, unobstructed
airflow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE,
RESULTING IN INJURY:
Do not exceed the tool's maximum
air pressure rating.
If the tool still does not have sufficient
force at maximum pressure and
sufficient airflow, then a larger tool
may be required.
Note: While working on roofs, tar and
dirt may build up on the Nose of the
Roofing Nailer. This can prevent
normal operation. Remove buildup
with a nonflammable solvent.
NEVER use gasoline or other
flammable solvents. Do not immerse
the Roofing Nailer in an approved
solvent beyond the height of the nail
heads, to avoid getting the solvent
into the drive cylinder of the tool. Dry
off the Roofing Nailer before use;
any oil film left after cleanup will
accelerate tar buildup.
6. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is disconnected and is
incapable of firing any fasteners.
d. Release the trigger again.
e. Clean external surfaces with
clean, dry cloth.
f. Store indoors out of children's
reach.
Page 14 For technical questions, please call 1-800-444-3353. SKU 92917
93253