Download Print this page

Ferimex Outdoor Client User Manual

Outdoor wireless device

Advertisement

Quick Links

Outdoor Client
User's Guide
Ferimex IT spol s r.o.
Výtvarná 8
Bratislava
officeba@ferimexit.sk
tel.: +421/2/4564 1701
www.ferimex.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the Outdoor Client and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ferimex Outdoor Client

  • Page 1 Outdoor Client User’s Guide Ferimex IT spol s r.o. Výtvarná 8 Bratislava officeba@ferimexit.sk tel.: +421/2/4564 1701 www.ferimex.com...
  • Page 2 OUTDOOR CLIENT Description The Outdoor Client is an outdoor wireless device used to connect a client to a wireless network. It is designed to operate in outdoor conditions, and has water resistant hou- sing which allows for easy installation on the roof with short cables directly to an exter- nal antenna.
  • Page 3 Outdoor Client back panel holes. Antenna elevation and azimuth are set together with the device. Antenna connection The RF interface on the Outdoor Client is an N/female type connector. You need to connect an antenna cable with N/male type connector. You don‘t need any pigtails for the connection.
  • Page 4 For a LAN connection you can use the ethernet card installed in your computer, or a Switch (HUB). The switch standard you need is 10Base-T or 10/100Base-T. Cross cab- le is used when the Outdoor Client is connected directly to an ethernet card in a com- puter. Connect the cable to the connector Lan-In POE.
  • Page 5 OUTDOOR CLIENT Information You can see the actual configuration and the wireless state. ESSID, Channel, conne- ction rate, link quality, actual IP address are the most important parameters to check. Wireless Settings Operating Mode Infrastructure or Ad-Hoc mode switch. Information Ad-Hoc mode.
  • Page 6 Radio channel setting. Choose one of the available channels different from the other wireless network channel. You can choose the channel in AD-Hoc mode. In infrastructure mode you don’t need to set the channel. The Outdoor client will scan the band and stop after it finds traffic with the same ESSID.
  • Page 7 All non-encrypted data will be ignored when you turn on this switch. Shared Key Authentification Open System – Devices can be connected to the Outdoor Client during the aut- hentification process without using WEP. Shared Key – Only devices with correct WEP phrase during the authentification process can connect to the Outdoor Client.
  • Page 8 OUTDOOR CLIENT Default IP address Device IP Default Subnet Mask Mask Default gateway Router IP address on network Device name Not required – Name of user or connection name Allow Upgrade uploads It is possible to change firmware when this parameter is on.
  • Page 9: Package Content

    1x Outdoor Client 1x Power Over Ethernet HUB 1x User guide Atttention! This device is only for expert use. If you are not sure about one of the points in this guide ask Ferimex IT for help or consult a network expert.
  • Page 10 OUTDOOR CLIENT Technical parameters of Ferimex Outdoor Client: Lan Port: RJ-45 10Mbps network interface LED: LEDx3: Ethernet Activity, RF Activity, Power Wlan Port: N-Type Female Standard: IEEE 802.11b DSSS, WiFi, Ethernet 802.3 Frequency bands: 2.400 ~ 2.4853 Ghz ISM Band Modulation: 1Mbps:DBPSK, 2Mbps: DQPSK, 5.5 and 11Mbps: CCK...
  • Page 11 Ferimex IT spol s r.o. Výtvarná 8 Bratislava officeba@ferimexit.sk www.ferimex.com...