Advertisement

Quick Links

XTDT AMPLIFIERS
XTDT AMPLIFIERS
DIGITAL TECHNOLOGY
AMPLIFIERS
Owner's manual
1/14

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XTDT series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for X-TREME XTDT series

  • Page 1 XTDT AMPLIFIERS XTDT AMPLIFIERS DIGITAL TECHNOLOGY AMPLIFIERS Owner’s manual 1/14...
  • Page 2: Table Of Contents

    Owner’s manual DIGITAL TECHNOLOGY SERIES AMPLIFIERS Owner’s Manual CONTENTS 1. Important safety instructions 2. Declaration of compliance 2.1 User’s liability 3. Introduction 3.1 Unpacking 3.2 Installation/Assembly 3.3 Front panel 3.4 Rear panel 4. Brief description of the product range 5. User instructions 5.1 Maximum power consumption 5.2 Cooling 5.3 Settings...
  • Page 3: Important Safety Instructions

    XTDT AMPLIFIERS 1. Important safety instructions This symbol indicates the presence of important user instructions 11. Disconnect the appliance in case of storm and if unused. and information that should be given particular attention so as to 12. Connect according to the instructions only. use the product properly.
  • Page 4: Declaration Of Compliance

    Even if there is a gain reduction through have to return it to X-Treme or to one of its dealers. Use the origi- the attenuators on the amplifier’s front panel, it is still possible to...
  • Page 5: Front Panel

    XTDT AMPLIFIERS 3.3 Front panel: controls and indicators Fig.3 a) Front panel mod. XTDT3200 and XTDT3800 Fig.3 b) Front panel mod. XTDT4800F and XTDT6000F 1) Holes for the assembly 8) Hi-Temp LED It indicates when the dissipator temperature starts increasing. At 2) Holes for standard rack handles 60 ºC the Hi-Temp LED will start flashing and the output power will be gradually reduced.
  • Page 6: Rear Panel

    Owner’s manual 3.4 Rear Panel: controls and connectors fig.4 a) Back panel mod. XTDT3200 and XTDT3800 fig.4 b) Back panel mod. XTDT4800F and XTDT6000F 12) Fan discharge grids 16) Switch for mode setting The fan of the cooling system creates an airflow with front/back Switch to set the usage mode (refer to drawings 5, 6 and 7).
  • Page 7: Brief Description Of The Product Range

    XTDT4800F and XTDT6000F are four channel models supplying up to 1200 W and 1500 W respectively per channel at 4 Ω. All XTDT series amplifiers have been fully designed with switching technology (both the supply power unit section and the power stage) •...
  • Page 8: User Instructions

    Owner’s manual 5. User instruction 5.1 Maximum power consumption Check whether there is enough power to supply the amplifier (refer to the data at the end of this manual). Please ensure that the voltage of the network complies with the instructions found at the back of the amplifier.
  • Page 9 XTDT AMPLIFIERS fig. 6 a) Bridge Mono Mode mod. XTDT3200 and XTDT3800 fig. 7 a) Parallel Inputs (Link) mod. XTDT3200 and XTDT3800 Balanced Connection Balanced Connection shield inverting non-inverting shield 6.3mm (1/4-inch) TRS, XLR inverting non-inverting 6.3mm (1/4-inch) TRS, XLR Unbalanced Connection jumper Unbalanced Connection...
  • Page 10: Ouput Stage Block Diagram

    Owner’s manual 6. Output stage block diagram Thermal Protect Overcurrent monitor Mute Bus CH A input Half Multiple Output controller & Limiter Error bridge Gain Modulator stage (30 - 75 Hz) Circuit amplifier power Thermal – (26 ÷ 44 dB) driver stage monitor...
  • Page 11: Protection Features

    Please contact the nearest X-Treme Assistance Service (Distribu- Temp starts flashing if the dissipater reaches a temperature of 60º tor or Dealer) or directly X-Treme Audio for maintenance assist- C. In such case the input signal of the relevant channel will be ance.
  • Page 12: Technical Features

    Owner’s manual 8. Technical features • TWO channels Models XTDT3200 XTDT3800 Power Output (per Channel) 8 Ω 850 W 1100 W 4 Ω 1600 W 1900 W 2.7 Ω 1800 W 2400 W 2 Ω 2000 W Bridged Mono Power 8 Ω...
  • Page 13 XTDT AMPLIFIERS • FOUR channels Models XTDT4800F XTDT6000F Power Output (per Channel) 8 Ω 700 W 850 W 4 Ω 1200 W 1500 W 2.7 Ω 1550 W 1800 W 2 Ω Bridged Mono Power 8 Ω 2 x 2400 W 2 x 3000 W 4 Ω...
  • Page 14 X-Treme Audio reserves the rights to change or modify products and specifications at any time without prior notice. X-Treme and the corresponding symbols, images and registered trademarks are of exclusive property of Sound Corporation group. © 2010 Sound Corporation group. All rights reserved.

Table of Contents