Samsung LN26A450C1D Quick Setup Manual page 11

Connecting a VCR
Video Connection
TV Side Panel
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
➣
Each VCR has a different back panel configuration.
➣
When connecting a VCR, match the color of the connection terminal to the cable.
➣
When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable
(Yellow).
S-Video Connection
TV Side Panel
TV Rear Panel
Audio Cable
5
(Not supplied)
Video Cable
4
(Not supplied)
TV Rear Panel
VCR Rear Panel
RF Cable
3
(Not supplied)
VCR Rear Panel
RF Cable

(Not supplied)
Audio Cable
2
(Not supplied)
S-Video Cable
3
(Not supplied)
English-
Unplug the cable or antenna

from the back of the TV.
Connect the cable or antenna
2
to the ANT IN terminal on the
back of the VCR.
Connect an RF Cable between
3
the ANT OUT terminal on the
VCR and the ANT IN terminal
on the TV.
Connect a Video Cable
4
between the VIDEO OUT jack
on the VCR and the AV IN 1
[Y/VIDEO] or AV IN 2 [VIDEO]
jack on the TV.
Connect Audio Cables between
5
the AUDIO OUT jacks on the
VCR and the AV IN 1 (or AV IN 2)
[R-AUDIO-L] jacks on the TV.
➣
If you have a "mono" (non-stereo)
VCR, use a Y-connector (not
supplied) to hook up to the right
and left audio input jacks of the
TV. If your VCR is stereo, you
must connect two cables.
To begin, follow steps 1–3 in

the previous section to connect
the antenna or cable to your
VCR and your TV.
Connect Audio Cables between
2
the AUDIO OUT jacks on the
VCR and the AV IN 2
[R-AUDIO-L] jacks on the TV.
Connect an S-Video Cable
3
between the S-VIDEO OUT jack
on the VCR and the AV IN 2
[S-VIDEO] jack on the TV.
An S-Video cable may be included
with a VCR. (If not, check your local
electronics store.)
➣
Each VCR has a different back
panel configuration.
➣
When connecting a VCR, match
the color of the connection
terminal to the cable.